Elk M1XSP Supplementary Instructions & Release Notes

M1XSP Installation and Setup ..................................................................................................................................... 2 ELK-M1 Data Bus E.O.L. Termination ..........................................................................................................................3 INSTEON ** Light ...

M1XSP Diagnostic LED indicator Slow blink (1/2 sec.) = Normal communication with M1. Fast flicker = Communicating with other equipment (Thermostat, Lighting Controller, PC, etc.) No blink = No communication with M1. Unit might be unplugged or powered off. M1XSP Installation and Setup 1. The M1XSP ope ...

VERY IMPORTANT! The control uses a RS-485 “differential” data bus operating at 38,400 bits per second. This is relatively high speed by industry standards and ensures fast, accurate communications. EOL data bus terminating resistors are strongly suggested to eliminate the possibility of reflecti ...

INSTEON ** Lighting Control ONLY ** INSTEON - INSTEON utilizes Powerline Communications (PLC) technology. Numerous device types are available; such as: Light Switches, Lamp Modules, Applicance Modules, Keypad Controllers, etc. A unique feature of INSTEON is the availability of RF signal enhancer ...

6. Update the firmware in the M1XSP to version 50.1.4 (or the latest 50.x.x version). Download from the Elk website. 7. Use the ELK-RP Software to program the M1 Lighting device attributes for devices 1 through 192 as: Format = Serial Expander, Type = Dimmer (Type may alternately be On/Off Switc ...

Factory Defaulting INSTEON Devices During installation or troubleshooting it may be necessary to factory default one or more devices. For example; multiple devices may inadvertently become cross-linked together, making them turn on together when they should be separate. This is caused by accidentall ...

INSTEON Device 1 Device 2 Device 3 Device 4 Device 5 Device 6 Device 7 Device 8 Device 9 Device 10 Device 11 Device 12 Device 13 Device 14 Device 15 Device 16 Device 17 Device 18 Device 19 Device 20 Device 21 Device 22 Device 23 Device 24 Device 25 Device 26 Device 27 Device 28 Device 29 Device 30 Dev ...

Changes effective with this new application firmware: NOTE: Updating will ERASE ALL linked Insteon devices! 1. Found a reported problem of the M1XSP occasionally defaulting itself (erasing all enrolled devices) upon power up. Added a 1 second debounce timer upon power-up before reading the state of Ju ...

Changes effective with this new application firmware: NOTE: Updating will ERASE ALL linked Insteon devices! 1. Polling for status after a manual switch press - Added a new routine to make the M1XSP poll a device if it detects release of the on or off switch. This should improve the ability for the M1 ...