Baker Hughes Masoneilan SVI FF Quick Start Manual

Advanced Performance Digital Positioner Bench Quick Start (Rev E) Instruction Manual BHGE Data Classification: Public ...

2 | BHGE About this Guide This instruction manual applies to the following instruments and approved software: SVI FF with firmware version 1.0.0.x or higher with ValVue* version 3.x SVI FF DTM version 1.00.X or 1.1.0.0 or 1.2.0.x The information contained in this manual, in whole or part, ...

Masoneilan SVI FF Bench Quick Start Manual =| 3 Bench Quick Start The goal of this procedure is to perform a configuration of the SV FF up to running Find Stops and Autotune on a bench. This procedure uses BHGE’s ValVue3 software and the SVI* FF DTM. This procedure consists of the following majo ...

4 | BHGE 1. Physical Setup 1. Buy the National Instruments® (NI) hardware/software. For suggested components as of May 2014, see “Appendix A: Suggested NI Hardware” on page 15. 2. Install the NI software (NI-FBus Communication Manager minimum) that comes with the NI hardware and restart the ...

© 2019 Baker Hughes, a GE company, LLC. All rights reserved. 2. Software Install and Configuration 1. Start the NI the FBus Communication Manager. 2. Download the SVI FF DTM and ValVue3 and install. See “Appendix B: Download Instructions” on page 16 for download site. Masoneilan recommends using Version 4 ...

6 | BHGE 3. Sign on to ValVue3 with default values (first time only): User name admin. Password ValVue3. For security purposes, change your password during the first use. The ValVue and SVI FF DTM license trial period works as follows: 1. Once you download and install the ValVue software, you ...

© 2019 Baker Hughes, a GE company, LLC. All rights reserved. 4. Click Settings > DTM Library and Figure 3 appears. Figure 3 DTM Library Management 5. Click Update and once the DTM Updates list refreshes, select the GE NI-FBUS-FF DTM and the SVI FF and click Add Sel. 6. Click OK to close DTM Library Management ...

8 | BHGE 8. Click OK again to add the FF H1 Interface to Network View (Figure 5). Figure 5 Network View 9. Right-click on the FF H1 Interface and click Add New Device and Figure 6 appears. Figure 6 Add New Device 10. Connect the SVI FF to the power hub leads. The connection is not polarity sensiti ...

© 2019 Baker Hughes, a GE company, LLC. All rights reserved. 12. Right-click FF H1 Interface, click Additional Functions > LiveList. LiveList appears (Figure 7). Figure 7 LiveList 13. Locate Actual Devices, which shows the address for the SVI FF connected to the H1 network. In this example the SVI FF has 22 as ...

10 | BHGE 18. Check that the SVI FF is connected (see red oval in Figure 8). Figure 8 Connected If not it does not connect, correct the address using the address on the DTM screen. Disconnect and then reconnect. A dialog appears asking whether to upload all parameters. 19. Click Yes. If the dialog ...