AlarmForce DXS-14 Operating Instructions Manual

675 Garyray Drive Toronto, ON M9L 1R2, Canada PRINTER’S INSTRUCTIONS: INSTR,INSTL,DXS-14 - LINEAR P/N: 233766 X3 - INK: BLACK - MATERIAL: 20 LB. MEAD BOND - SIZE: 5.500” X 8.500” - SCALE: 1-1 - FOLDING: ALBUM FOLD - BINDING: SADDLE-STITCH ...

Security System Panels. The wireless keypad transmits key presses to the panel and displays alphanumeric data received from the panel. A press of any key puts the keypad in a fully operational mode with backlit LCD and RF Transceiver active. After 15 seconds of inactivity t ...

The keypad has a real time clock (RTC) that must be set during installation and after battery replacement. The RTC is required for the keypad to display time- and date-stamped events, using time offset data received from the panel. Time and date are also shown during the keypad status display when the keypad fi rst wakes up: KEYPAD READY ...

In most operations, the keypad will only send key presses to the panel and in response the panel will update the display, LED and tone annunciations as needed to refl ect the current state of the system. When doing an initial installation or manually activated program updates the keypad will function autonomousl ...

packet. Individual arm or disarm events are sent from the panel to the keypad in a single message packet; if arming, any bypassed zones are also included (up to 15) in the same message packet. These events are displayed one event at a time on the LCD. The user may scroll throu ...

The keypad communicates a low battery condition to the panel through the low battery bit set in the KEY PRESS message. If the battery is low, on keypad wake up the keypad will indicate a fault condition (beep and fl ash the LED red once) while briefl y displaying on the LCD a low battery prompt, instead of the usual keypad ready messa ...

The keypad has a wireless transceiver module that communicates with the microprocessor via a serial UART. The internal antenna is used for both transmit and receive functions. The transceiver module is mounted in a shielded enclosure for RFI protection. RF Transceiver Specifi cations The transceiver complies with FCC Part 15 and ISC ...

This device complies with FCC Rules and Regulations as Part 15 Rules and Regulations and Industry Canada license exempt RSS standards. Operation is subject to the following two conditions: 1.This device may not cause harmful interference and 2. This device must accept any interference received, including interference that may c ...