APART PA-CONF-E Manual
Text of APART PA-CONF-E Manual
The APart PA-CONF-E is an easy to use professional microphone pre amplifier system. It is equipped with
an input for the APart conference microphone terminals, an extra Mic/Line input with lo-cut on/off button
(e.g. For wireless microphones) and a line input. An independent volume control is available for the
conference terminals, the extra MIC/Line input and the line input. This line input also has a 3 band tone
control. The overall
APART PA-CONF-E 1. Conference microphones input jack: connect microphones from the PA-CONF-E manufacturer only. This
jack is wired in parallel to the jack connector at the rear of the unit. You can use the front OR rear jack
depending on the cabling situation. !!! DON’T USE BOTH INPUTS SIMULTANEOUSLY !!! Switch of the
mains current and turn all volumes down before connecting the conference microphones to the CONF
INPUT.
2. IR eye window: with th
1. Conference microphones input: connect conference microphones from the PACONF-E manufacturer
only ! Switch off mains current supply and turn all volumes down before connecting any microphones to
the system. Start by connecting the chairman’s microphone’s output fi rst, then daisy chain the delegate’s
microphones to the input of the chairman’s microphone and so on... Always use balanced cables.
2. Extra microphone input: bala
12. 5-24 V on/off: the PA-CONF-E can be switched on or off using a 5 – 24 VDC voltage. Mind the polarity
as indicated on the rear panel ! When the unit has been switched to standby mode using the remote
control, it can be switched on again by applying a 5 to 24 VDC voltage to this euroblock connector.
The unit will remain switched on as long as the DC voltage is present on this input.
13. GND lift switch: in case hum or buzz appe
The remote control shipped with the main unit can be used to control
some basic functions, and is compatible with the APart PIR7600
pre-amplifi er also. Some functions are not available on the
PA-CONF-E unit.
Conference mic input (front & rear TRS jack)
-9 dB / 1k ohm
Conference mic power supply
15 VDC regulated / 1.5 A multifuse protected
Ext mic input mic/line (XLR input)
-10 dB / -60 dB / 5.6
APART PA-CONF-E • Please check the carton box for any kind of damage on reception of the goods.
In case of a damaged carton, please contact your dealer before opening the carton.
• Read all documentation before operating your equipment.
• Keep all documentation for future reference.
• Save the carton and packing material even if the equipment has arrived in good condition.
• Should you ever need to ship the unit, use only the original f
Company names, product names, and names of formats etc. are the trademarks or
registered trademarks of their respective owners.
© 2009 APart-Audio specifications subject to change without notice.