Aetechron 7228 Operator's Manual

Text of Aetechron 7228 Operator's Manual

Single-Channel Industrial Amplifier for Demanding, High-Power Systems

574.295.9495 | www.aetechron.com 2507 Warren Street, Elkhart, IN 46516

Limited One-Year Warranty

we will give you an authorization to return the product for service. All components must be shipped in a factory pack or equivalent which, if needed, may be obtained from us for a nominal charge. We will take corrective ac- tions within a reasonable time of the date of receipt of the defective product. If the repairs made by us are not satisfactory, notify us immediately. DISCLAIMER OF CONSEQUENTIAL AND INCIDENTAL DAMAGES You are

DECLARATION OF CONFORMITY

Technical Construction File Route Issued By: AE Techron, Inc. For Compliance Questions Only: Larry Shank 2507 Warren Street 574-295-9495 Elkhart, IN 46516 [email protected] This Declaration of Conformity is issued under the sole responsibility of AE Techron, Inc., and belongs to the following product: Equipment Type: Industrial Power Amplifiers Model Name: 7228 EMC Standards: EN 61326-1: 2013 – Electrical Equipment for Measur

Information subject to change

5 7228 OPERATOR’S MANUAL – SECTION 1 1  Introduction Congratulations on your purchase of the 7228 power amplifier. The 7228 was developed to bring performance improvements and an extended fea- ture set when compared to AE Techron’s industry standard 7224 amplifier. The 7228 amplifiers are built and tested to the most stringent quality stan- dards for long life and outstanding performance. The AE T
Information subject to change 97-8004188-B_04-03-18 7228 OPERATOR’S MANUAL – SECTION 2 6 2  Amplifier Unpacking and Installation The 7228 amplifier is a precision instrument that can be dangerous if not handled properly. Lethal voltages are present in both the AC input supply and the output of the amplifier. For this reason, safety should be your primary concern when you setup and operate this amplifier. 2.1  Safety First Throughout this manual spe
Information subject to change 7 7228 OPERATOR’S MANUAL – SECTION 3 3  Connections and Startup This section details the wiring and startup pro- cedures for a single 7228 amplifier operating in Controlled-Voltage mode (factory default). Before connecting the amplifier, make sure the AC power cord is unplugged. 3.1  Other Operation Modes and Configurations The 7228 amplifier can be field-configured for operation in a number of wa
Information subject to change 97-8004188-B_04-03-18 7228 OPERATOR’S MANUAL – SECTION 3 8 Figure 3.2 – Connecting the Load Always use the appropriate wire size and insula- tion for the maximum current and voltage expected at the output. Never connect the output of the amplifier to any other model amplifier, power sup- ply, signal source, or other inappropriate load; fire can result. 3.2.2  Connecting the Outputs Connection to the output of the ampli
Information subject to change 9 7228 OPERATOR’S MANUAL – SECTION 3 tions by connecting/disconnecting the inverting (–) pin on each input connector to the amplifier ground through a 5-ohm resistor (see Figure 3.5). When DIP switch #5 is placed in the UP position (factory default), the shield on the BNC connector and the inverting (–) pin on ther terminal block con- nector are tied to the amplifier ground, allowing the connector

Aetechron Amplifier Owners Instructions: