Aeronaut Ramboline Manual 

radio-controlled bow flap which is actuated by a sailwinch. A bow thruster can be fitted for improved manoeuvrability. The barge can carry payloads weighing up to about 14 kg, and the load bay dimensions can accommodate art ...

deck 33. These parts are 495 mm long, and should be positioned with an adequate projection at front and rear. There should be a gap between the girders. Do not glue the deck in place at this stage. Glue the rails 15a to the frames. Take care to maintain the project ...

the drawing alongside. Fit the two 80 mm lengths of brass rod 26 through the holes. 8. Fit the two brass brackets 25 in the openings in the deck from the underside. The upper rod 26 should rest against the underside of the deck 33; the lower rod on the RC plate. Glue t ...

Fig. 14 43 Fig. 12 BSR 34 13 Fig. 13 22 23 21 Carriageway deck 45 not shown ! 34 t 12. Open up the bow thruster stubs (BSR). Slide the extension tubes 43 through the holes in the bow thruster box from the outside. Working inside the box, fit the extension tubes 43 on the bow thruster stubs. The glued joints between these parts mu ...

the deck. Glue parts 37 and 38 together to form the fairing cover. When the sailwinch has been installed, secure the cover on the fairing using contact cement or similar. Glue parts 39 and 40 together, taking care to maintain the correct position of the screw-holes ...

Unterlage 70 anpassen Bild 20 - Cut the servo support 70 to suit Remove the coupling box, place the box cover 60 / 61 on the deck at the marked point, and drill four 1.9 mm Ø holes in the deck of the Ramborator, working through the holes in the cover. Drill a further hole in the deck for the servo lead. Fit the shaft 63 through the holes, and attac ...

Bow thruster Order No. 7020/11 Cable, 1.5 mm², 2 m Order No. 7457/41 Adhesives UHU plast spezial Order No. 7632/06 or Ruderer Order No. 7646/42 or UHU Allplast Order No. 7632/06 Stabilit express Order No. 7646/02 (80 g) Sailwinch Standard servo size, 2 - 4 turns Mini-servo, approx. 23 x 12 x 25 mm Rubbing str ...

Order No. 3048/00 Springer Tugs are self-propelled vessels employed on American rivers for transport duties and manoeuvring tasks; they are very simple and quick to construct. In model form they are also very simple, and since they can be built quickly, Springer Tug matches with these models rapidly developed in England and ...

9 Parts list Nr. Description Quant. Material Laser sheet Form Dimensions 1 Hull bottom 1 ABS 1 Laser-cut 2 mm 2 Frame 1 ABS 2 Laser-cut 2 mm 3 Frame 1 ABS 2 Laser-cut 2 mm 4 Frame 1 ABS 2 Laser-cut 2 mm 5 Frame 1 ABS 2 Laser-cut 2 mm 6 Frame 1 ABS 2 Laser-cut 2 mm 7 Frame 1 ABS 2 Laser-cut 2 mm 8 Frame 1 ABS 2 Laser-cut 2 mm 9 Frame 1 ABS 2 Laser-cut 2 mm 10 ...