ADEMCO 5817CB Installation And Setup Manual

This device complies with Part 15 of FCC rules and RSS210 of IC. Operation is subject to the following two conditions: (1) this device may not cause harmful interference. (2) this device must accept any interference received, including interference that may cause undesired operation. Note: The user shall not make any changes or modifications to the equipment unless authorized by the Installation and Setup Guide or User Guide. Unauthorized changes or modifications could void the user's authority to operate the equipment. UL For dry, indoor use only. Do not install in air-handling spaces. For the latest warranty information, please ...

- 3 - 6. Attach the case back to the mounting plate by sliding the keyhole slots in the case back down onto the mounting plate's holding posts. The locking tab will click as the case back locks in place. To disengage the unit from an installed mounting plate, insert a small screwdriver into the mounting plate release hole, push down to retract the locking tab, and push upward on the unit to disengage from posts. If not using the mounting plate, it is necessary to remove the PC board from the case back. Slide a small flat bladed screwdriver between the case back and PC board near the board hold-down clip and carefully pry the board out. 7. In the ...