Olympus CX31 User Manual Manual

Text of the manual

A X 6 6 5 4

This instruction manual is for the Olympus Biological Microscope Model CX31. To ensure the safety, obtain optimum performance and to familiarize yourself fully with the use of this microscope, we recommend that you study this manual thoroughly before operating the microscope. Retain this instruction manual

IMPORTANT — Be sure to read this section for safe use of the equipment. — 1-3

1 NOMENCLATURE 4 2 SUMMARY OF BRIGHTFIELD OBSERVATION PROCEDURE 5 3 ASSEMBLY — See this section for the replacement of the light bulb. — 6-7 4 USING THE CONTROLS 8-14 5 TROUBLESHOOTING GUIDE 15-16 7 OPTICAL CHARACTERISTICS 18 4-1 Base.......................

1. After the equipment has been used in an observation of a specimen

that is accompanied with a potential of infection, clean the parts coming in contact with the specimen to prevent infection. · Moving this product is accompanied with the risk of dropping the specimen. Be sure to remove the specimen before moving this product. · In case

A warning label is affixed at parts where special precaution is required when handling and using the microscope. Always

heed the warnings. Fig. 2 Indicates that the surface becomes hot, and should not be touched with bare hands. Before use, carefully read the instruction manual. Improper handling could result in personal injury to the user and/or dam

1. Clean all glass components by wiping gently with gauze. To remove fingerprints or oil smudges, wipe with gauze

slightly moistened with a mixture of ether (70%) and alcohol (30%). Since solvents such as ether and alcohol are highly flammable, they must be handled carefully. Be sure to keep these chemicals away from open flames or potential sources of ele

}The revolving nosepiece is fastened with a band to prevent it from turning during transportation. Remove the band when

unpacking the microscope. Be sure to store the band for re-transportation of the microscope. * The stage is shipped with the two transport pins locked. When using the microscope for the first time, remove the transport l

SUMMARY OF BRIGHTFIELD OBSERVATION

PROCEDURE 1 2 3 4 5 6 7 8 9 · Turn the revolving nosepiece to engage the 10X objective. #Make sure that the revolving nosepiece stops with an audible click. · Place a specimen on the stage. (Page 10) · Turn the X-axis knob and Y-axis knob to move the specimen into the light path. (Page 11) · Set the main switch to

1. Turn the microscope frame on its side and pull the lamp housing

knob @ on the underside of the base to open the lamp housing cover. 2. Holding the halogen bulb ² contained in the polyethylene bag to avoid leaving fingerprints on the bulb, fully insert the contact pins into the bulb socket ³ When properly seated, pull off the polyethylene

Other Microscope Manuals