LeakAlertor 6000 Operation & User’s Manual

www.leakalertor.com tel: 610.594.2191 |toll free: 877.532.5253 LA6KUGPC67 JUN17A 15 E. Uwchlan Ave Ste 412 | Exton, PA 19341 Installing Your LeakAlertor – This is SO easy! 1) Remove tank lid. 2) Place the LeakAlertor over the edge of the tank. 3) Replace tank lid. 4) Pull battery tab. (Gently press the unit against the tank while pulling the tab straight down to remove.) 5) That’s It!! You’re Done! I Just Pulled the Battery Tab…Now What Happens? ➢ When the battery tab was pulled, you probably noticed that the LEDs (the colored lights) flashed and the unit beeped – the LeakAlertor now needs some time to get ready to work on your toilet. ➢ For the next hour, you will see the GREEN LED flashing – this is normal. Feel free to use your toilet during the time – you won’t upset the LeakAlertor. ➢ When the RED, YELLOW, and GREEN LEDs begin to flash together, go ahead and flush the toilet. Don’t worry if you can’t get to flushing the toilet right away – the LeakAlertor will patiently wait for you. ➢ The LeakAlertor is now working and will let you know if there is a problem. How do I know if I have a problem with my toilet? Every time you flush the toilet, watch, and listen to the LeakAlertor! *See the LA 6000 Support Page on the website for more detailed information.

www.leakalertor.com tel: 610.594.2191 |toll free: 877.532.5253 LA6KUGPC67 JUN17A 15 E. Uwchlan Ave Ste 412 | Exton, PA 19341 Using the RESET button Use the RESET function to: • Temporarily silence the alerts • Make a repair to the toilet • Temporarily remove or store the unit ➢ The RESET button is recessed inside the enclosure as shown in the figure below. ➢ Use a toothpick or pencil to press the button. To reset the LeakAlertor: 1) Press and Hold the RESET button. When the RED LED illuminates, immediately release the RESET button. 2) All three LEDs will flash once and the unit will beep once. 3) The GREEN LED will then flash for several minutes, after which all three LEDS will begin to flash at the same time. 4) Once all three LEDs are flashing at the same time Flush the toilet to complete the reset. You’re all done, the unit has been reset!! Testing the LeakAlertor - Easy as 1-2-3 Use the TEST function to confirm the unit is working as intended. ➢ While testing the unit, we recommend removing the toilet tank lid to observe the water height in the tank while the LEDs flash. ➢ Wait at least two to three minutes after you last flushed the toilet to begin a test of the unit. ➢ The unit will automatically exit the test mode after about three minutes To test the LeakAlertor: 1) Press and Continue to Hold the RESET button. The RED LED will illuminate, and then the YELLOW LED will illimnate. 2) Release the RESET button when the YELLOW LED illuminates. 3) Flush the toilet and watch the LEDs during the entire flush cycle*: • RED LED – The water level in the tank is falling • GREEN LED – The water level in the tank is rising * During the flush cycle and/or when the water has reached its lowest level in the tank during the flush, the water turbulence may cause the unit to appear as though the LEDs are flashing randomly. The unit is detecting the rising/falling water height of the turbulence and alerting accordingly. Once the water height begins to steadily rise, the unit will contine to flash the GREEN LED until the water height stabilizes at the end of the flush.