Graham Studios RXPC Instruction Manual

Text of Graham Studios RXPC Instruction Manual

RXPC Talk Table

Instruction Manual www.graham-studios.com ( 970 ) 225-1956 Copyright 2013 Graham Studios LLC

This manual is a generic guide. The assembly of a Talk Table and is used as an

example. Your particular configuration may vary. Please refer to your personalized shop drawing included in packaging. Please call the factory if you have any questions at (970) 225-1956. Tools needed : 1. #2 Phillips screw driver ( Power drill with barrel magnet makes it much easier ) 2. 2 each— 7/16” open end wrenches Table of Contents 1. Equipment/PBC cabinet ass

Equipment / PBC Cabinet Assembly

Equipment cabinet — Attach 3 Universal Brackets on each leg using 3/4 Truss head screws Note : U Clip on Rear of each cabinet PBC / Utility Cabinet — Attach 4 Universal Brackets on each leg w/ 3/4 Truss head Note: U Clip on Rear of each cabinet Inside leg Outside leg Wire Egress Inside leg Outside leg Hole for shelf clip Hole for shelf clip Thru holes to bolt cabinets together Surface Mount

Attach Stringers to Both legs with surface mounts

Attach utility panel to punch block cabinet with 3/4 Truss head screws Note : Door stops on Rear of cabinet Utility / PBC cabinet leg Utility/PBC Cabinet Equipment Cabinet Rack rail

Insert 2 Clips on each leg

Lay cabinets on their sides Install Bases Secure bottom with #6 5/8 Phillips pan head screws View of Bottoms installed

Attach Rear Door with 1/4 x 20 machine screws and finish washers

Bolt Rack & PBC Cabinets together with 1/4 x 20 Bolts at top and bottom Front view Utility/PBC cabinet Equipment cabinet

Graham Studios Indoor Furnishing Owners Instructions: