Hot Wheels B610S Instruction Manual

letters are used in these instructions to indicate which track piece goes where. Following the layout drawings on the Assembly Map, you may want to lay out your track – without connecting any track pieces. That way you’ll be able to see how the track layout goes together. 2. To connect track pieces: working on the flat surface, push the ends of the track pieces together. Make sure they snap toget ...

To make assembly easier, we’ve divided the process up into easy steps. You’ll assemble one section of track at a time, connecting the sections together as you go. A. A A. B A. F A. C A. D A. E LOOP ASSEMBLY First, let’s assemble the loop section. The following draw- ings shows you, step by step, how to assemble this section. Take your time, and refer to the Layout Drawings on the Assembly Map if you need to. a c The loop is ...

drawings show you, step by step, how to assemble this section. Take your time, and refer to the Layout Drawings on the Assembly Map if you need to. b 4 x GUARDRAILS 4 x 9" RADIUS CURVE 2 x 15" STRAIGHT 2 x #2 SUPPORTS 2 1 x 9" STRAIGHT 1 x #3 SUPPORTS 3 1 x #4 SUPPORTS 4 1 x #5 SUPPORTS 5 These are the pieces you’ll need to assembl ...

assembly, make sure you’re working with the track pieces against the wall…for added support. Once this section is complete, you’ll connect it to the loop section. Take your time, and refer to the Layout Drawings on the Assembly Map if you need to. You Are Here 1 x GUARDRAIL 1 x 9" STRAIGHT C 2 x 6" STRAIGHT 1 x 12" RADIUS 1/8 J 4 x TRANSITION ...

lowing drawings show you, step by step, how to assemble this section. Take your time, and refer to the Layout Drawings on the Assembly Map if you need to. You Are Here 3 x GUARDRAILS 2 x 12" RADIUS 1/8 J 1 x 9" RADIUS CURVE 8 x 9" RADIUS BANK TRACK H 2 x #4 SUPPORTS 4 1 x #5 SUPPORT 5 1 x #6 SUPPORT 6 1 x 15" STRAIGHT C 1 x 6" STRAIGHT 1 x #2 S ...

them as shown. To assemble a track support, sepa- rate the pieces as shown and snap off the connec- tor tabs (discard the tabs). Next, fit the two pieces together as shown. Insert the assembled track support into the round hole on the underside of the track as shown. c 1 4 3 A. F A. D A. E SQUEEZE TRACK SECTION You Are Here You’re almost done! Now let’s assemble the squeeze track section and complete our ...

❶Hand Controllers (2) ❷Yellow Hand Controller Plugs ❸Red Power Pack Plug ❹Terminal Track ❺Power Pack ❻Wall Outlet ❼Direction of travel a. Plug the Power Pack into a convenient wall outlet. b. The cables for the Power Pack and the hand controllers have color-coded plugs to help you make your connections properly. First, plug the red plug into the red recepta ...

the following driving tips and maintenance hints. DRIVING TIPS Here are some “inside” racing tips…for top performance! 1. Always race on a clean, hard, flat surface. For best rac- ing performance, we don’t recommend carpeting. 2. Clean track is IMPORTANT for best performance! Please refer to the Maintenance section for detailed instructions for cleaning the track. 3. Ra ...

Your car’s axle assembly may become “dislocated” from the chassis as a result of a sudden impact. To realign it, snap the assembly back into the chassis. DO NOT use any type of tool to snap the chassis back in place. Use only your fingers. 2. CHASSIS ALIGNMENT Occasionally check the position of the car’s body to make sure it is properly aligned and not rubbing against the tires. If necessary, carefully snap chas- sis ...