NatComm DP4 Manual 

the Manufacturers direct ph 800 530 8645 8AM - 5PM West Coast Pacific Time NATCOMM USA LLC Responsible Supplier Code NC ...

Description Page 3 Door Phone Dimensions Page 4 Description Continued Page 5 Door Phone Range Page 6 Door Phone Performance Page 7 Camera Power Page 8 Camera Wiring Page 9 Mounting the Door Phone Page 10 Operation Summary Page 11 Balance Pot Adjustment Pages 12-13 Wiring Diagrams Pages 14-15 Wiring Connection Pages 16-17 ...

to a Natcomm Door Station Controller (Models DS1-DS6). DP4 incorporates a Low Light, High Resolution CCD Color Camera, fitted in a sealed plastic enclosure. The Camera Circuit uses a High Resolution SONY sensor, which is designed to operate to at low lig ...

Back View Side View Front View 10.4 inches 10.4 inches 5.1 inches 1.5 inches ...

providing high quality cabling such as CAT5 is used. Note – Our DP1, DP2 and DP5 Door Phones can operate up to 300 yards from the Controller. The reduced distance specification of the DP4 Door Phone is due to the increased power requirements of th ...

A choice of Four Door Phones are provided for use with our range of Door Station Controller units: Model DP1 - SURFACE MOUNT  Molded plastic unit, designed for easy mounting direct onto your wall surface.  Red LED Night illumination. (4 in Wide, 5.25 in High, 1.25 in Depth). (100mm Wide, 133mm High, 32mm Depth). Mode ...

This product is IDEAL for RESIDENTIAL USE or COMMERCIAL USE, where ROAD NOISE is NOT HIGH. It is not designed for INDUSTRIAL USE where background noise will be constantly high. The volume of the audio communication on the internal phones should be comfortably audible (a similar level to a telephone call) providing:  T ...

CAMERA POWER Important Note: The DP4 Door Phone cannot be used more than 75 yards from the DS Controller The Integrated Camera is powered direct from the Door Phone, which receives its power via the 4 wire connection from the DS Controller. The power consumption of the Camera is approximately 150 mA and this cannot be supported over distanc ...

dedicated Video display units or both. If IP Video is required, the DP4 video output should be connected to an Analogue to Video IP Converter. A recommended device is the AXIS 241S. You can use either Coaxial cable or CAT5 cable to connect video to yo ...

MOUNTING THE DOOR PHONE The DOOR PHONE should be mounted at the average face height of 1.5 meter (5 feet) for optimum performance. The main body of the DP4 unit is designed to be recessed into a wall surface, unless you use the Optional Surface Mounting Kit (see below). A recess area of: 10.0 in x 3.7 in x 1.6 in (D) or 255 mm, 93mm and 40m ...