Lilin IPC0522 Quick Installation Manual

Do not install the equipment near any naked flames or heat sources
Do not expose this unit to rain, moisture, smoke or dust environment
Do not cover the opening of the cabinet with cloth and plastic or to install this unit in poor ventilated places. Allow 10cm between this unit and its surroundings
Do no ...

② Main body ③ Rear housing ④ Lens ⑤ IR LED ⑥ Microphone ⑦ Light sensor ⑧ PIR ⑨ White LED ⑩ Speaker ⑪ Doorbell button Unit: mm ...

wrench (FIG.1). Then, detach the main plastic body from the rear housing using a Philips screwdriver (FIG.2). 2. Drill holes on the wall according to the mounting position sticker (FIG.3). Note: a 6.3mm (1/4”) drill bit is recommended. 3. Insert an RJ-45 network cable ...

terminal separately (FIG.6). Then ensure the main plastic body and the rear housing are aligned and assembled properly before securing the screws (FIG.7). 5. Close the front metal cover, and tighten the two screws to secure the device (FIG.8). ...

① Micro SD Card Slot ② Reset Key ③ Wi-Fi Setup Button (Wi-Fi Model Only) 1. Press and hold the button for 2–5 seconds to enter the QR Scan Mode. 2. Press and hold the button for more than 6 seconds to enable the AP mode. ④ Wi-Fi Antenna Plug (Wi-Fi Model Only) ⑤ Video Output Connec ...

of the following system architectures: (1). Use a DC12V power adapter and a network switch to connect to the network. (2). Use a PoE network switch to connect to the network. (3). Use a PoE power injector and a network switch to connect to the network. HD Doo ...

To restore the hardware to factory default settings, please follow these steps: 1. Press and hold “RESET Key” for 10 seconds and release. 2. Wait for about 40 seconds, and the network LED light should turn off, and go back on again. 3. The camera is now restored to factory default settings, and will reboot automatic ...

To configure an IP address using the IP scan tool, you can copy the IPScan software from the installation CD, and paste to your computer. Alternatively, you can execute the IPScan software from the installation CD, or download the software from the Merit LILIN website (www.meritlilin.com). To change ...

To change an IP address via web interface, type the default IP address (192.168.0.200) in the Internet browser and follow the steps below: 1. Login to the H.264 Full HD IP camera by the default username “admin” and default password “pass” 2. Click Basic Mode configuration hyperlink. 3. Click Net ...