Scilogex MS-H-Pro Operation & User’s Manual

User Manual MS-H-Pro Digital Hotplate Magnetic Stirrer MS-Pro Digital Magnetic Stirrer Please read the User Manual and the related Video of this instrument on our website carefully before use, and follow all operating and safety instructions! The website www.scilogex.com Cat No.12300137 ...

3 2 Proper use 4 3 Inspection 5 3.1 Receiving Inspection 5 3.2 Listing of Items 5 4 Trial run 5 5 Control and Display 6 5.1 Control Elements 6 5.2 Display 7 6 Initialization 7 6.1 Initializing Sequence 7 6.2 Default Settings 7 ...

Preface Welcome to the “MS-(H)-Pro Digital（Hotplate） Magnetic Stirrer User Manual”. Users should read this Manual carefully, follow the instructions and procedures, and beware of all the cautions when using this instrument. Service When help needed, you can always contact the Sevice Department of man ...

1 Safety Instructions • When work ，wear the personal guard to avoid the risk from: - Splashing and evaporation of liquids - Release of toxic or combustible gases. • Set up the instrument in a spacious area on an stable, clean, non-slip, dry and fireproof surface, do not operate t ...

components. Safe operation is only guaranteed with the accessories described in the “Accessories” chapter. Accessories must be securely attached to the device and cannot come off by themselves. Always disconnect the plug before fitting accessories. • Ensure that the external temperature sensor is in ...

3 Inspection 3.1 Receiving Inspection Unpack the equipment carefully and check for any damages which may have arisen during transport. If it happens, please contact manufacturer for technical support. Note: If there is any apparent damage to the system, please do not plug it into the power line. 3.2 Listing ...

5 Control and Display 5.1 Control elements Mode Key Function Key LCD Temperature control knob (MS-H-Pro) LED Heat (MS-H-Pro) Speed control knob LED Stir Figure 2 Figure 3 Items Descriptions Speed control knod Stir Set the rated rotary speed. The function “Stirring” is switched ON or OFF via push the kno ...

5.2 Display Temp Stir ℃ Remote Set Probe Hot C B A Err Real value Rated value Temperature Stir Error Set Mode HotPlatewar ning External probe Remote control Figure 4 Characters Descriptions Temp and ℃Display temperature when the heating function is switched ON. Stir Display stirring state when the stirri ...

Items Default settings Operating mode A Setting temperature (°C ) 25 SAFE (℃ ) 350 Setting rotary speed (rpm) 100 Residual heat warning On Stirring bar breakaway monitoring OFF Table 4 6.3 Resetting parameters to factory settings Reset the parameters to the default settings, as follows: • Turn off by ...