schmersal Protect-IE Operating Instructions Manual
Read Online
Read the schmersal Protect-IE Operating Instructions Manual online using the built-in PDF viewer.
Key Pages of Document
1.1 Function This operating instructions manual provides all the information you need for the mounting, set-up and commissioning for the safe operation and disassembly of the input expander module. he operating instructions must be available in a legible condition and a complete version in the vicinity of the device. 1.2 Target group: authorised qualified personnel All operations described in this operating instructions manua ...
PROTECT-IE EN 1.6 Warning about misuse In case of inadequate or improper use or manipulations of the component, personal hazards or damage to machinery or plant components cannot be excluded. The relevant requirements of the standards ISO 14119 and ISO 13850 must be observed. 1.7 Exclusion of liability We shall accept no liability for damages and malfunctions resulting from defective mounting or failure ...
EN Monitored inputs: Cross-wire detection (Y/N): Yes Wire breakage detection (Y/N): Yes Earth leakage detection (Y/N): Yes Number of NO contacts: variant 02: 0; variant 11: 4 Number of NC contacts: variant 02: 8; variant 11: 4 Conduction resistance: max. 40 Ω Outputs: Number of enabling paths: 2 Number of auxiliary contacts: 0 Number of signalling outputs: 4 Switching capacity of the ...
PROTECT-IE EN 6.2 Maintenance A regular visual inspection and functional test, including the following steps, is recommended: 1. Check the correct fixing of the input expander module 2. Check the cable for damages 3. Check electrical function If a manual functional check is necessary to detect a possible accumulation of faults, then this must take place during the intervals noted as follows: • at least eve ...
EN Dual-channel antivalent control of magnetic safety sensors to IEC 60947-5-3 (see Fig. 7) • The control system recognises wire breakage and earth faults in the control circuit. • Cross-wire shorts between the monitoring circuits are detected. • If the inputs S1, S3, S5 and S7 are not used, they have to be bridged to +. • The unused inputs S2, S4, S6 and S8 remain vacant. S1 + S2 Y1 a) ...
PROTECT-IE K. A. Schmersal GmbH & Co. KG Möddinghofe 30, D - 42279 Wuppertal Postfach 24 02 63, D - 42232 Wuppertal Phone: +49 - (0)2 02 - 64 74 - 0 Telefax: +49 - (0)2 02 - 64 74 - 1 00 E-Mail: [email protected] Internet: http://www.schmersal.com 9. EU Declaration of conformity The currently valid declaration of conformity can be downloaded from ...
