AT&T PagePac Plus AmpliCenter Installation And Use Manual
Text of the manual
Copyright 1993 Harris Dracon
All Rights Reserved
Written/Printed in U.S.A.
AT&T 463-248-202
0II722051-300
Issue 1, March 1993
Notice
Every effort was made to ensure that the information in this guide was complete and accurate at the time of printing.
However, information is subject to change.
Federal Communications Commission (FCC) Interference Notice and Ca
About This Guide
How to Use This Guide
Before You Start
Installation Steps
Connectivity Chart
Product Safety Labels
Terminology
Reference Materials
How to Comment on This Guide
Shipping Container Contents
Ordering Information
Features and Capabilities
Specifications
1-2
1-2
1-2
1-3
1-4
1-6
1-6
1-6
1-6
1-7
1-
Installing the Hardware
3-1
I
I
I
I
I
I
I
Important Safety Information
Example System Setup
Mounting PagePac Plus AmpliCenter
Connecting Speakers
Telephone System Interface
Music Source Interface
System Testing
3-2
3-3
3-6
3-8
3-9
3-11
3-13
4.
Maintenance and Customer Support
4-1
I
I
I
I
I
In Case of Difficulty
4-2
Power Failure Operation
4-3
Common Probl
1-1. PagePac Plus Connectivity Chart
1-4
1-2. AmpliCenter Specifications
1-10
2.
Hardware Configuration
2-1. Controls and Indicators, Terminals and Connectors
2-1
2-4
v
1-1. Installation Steps
1-3
1-2. AmpliCenter Components
1-7
1-3. PagePac Plus AmpliCenter
1-9
2.
Hardware Configuration
2-1
2-1. AmpliCenter Controls and Indicators,
Terminals and Connectors
2-3
3.
Installing the Hardware
3-1
3-1.
3-2.
3-3.
3-4.
3-5.
3-6.
3-7.
AmpliCenter Interface with PagePac Plus Controller
3-4
Series AmpliCenters,
About This Guide
How to Use This Guide
Before You Start
Installation Steps
Connectivity Chart
Product Safety Labels
Terminology
Reference Materials
How to Comment on this Guide
Shipping Container Contents
Ordering Information
Features and Capabilities
Specifications
1-2
1-2
1-2
1-3
1-4
1-6
1-6
1-6
1-6
1-7
1-8
1-9
1-10
Overview 1-1
About This Guide
The PagePac Plus AmpliCenter Installation and Use Manual explains the
features of the AmpliCenter, how to install and configure the AmpliCenter,
and interface to a communication system and other auxiliary equipment.
It is intended that PagePac Plus be installed by a trained telephone, audio,
or electrical installer with basic electronic know
NOTE: The numbers in these
steps match the numbers in
figure 1-1.
1.
2.
3.
4.
5.
6.
7.
Mount the PagePac Plus AmpliCenter to either the wall, cabinet or a
rack.
Pull cables.
Hookup cabling to AmpliCenter and auxiliary equipment. (Refer to
Example Setups in section 3.) Use stick-on labels to identify the
AmpliCenter/zone (i.e., cafeteria -
The Connectivity chart gives the trunk interface requirements for the host
systems listed. This information is then used to set the telephone mode
function switch on the PagePac Plus AmpliCenter.
Table 1-1. PagePac Plus Connectivity Chart
Merlin Plus
Merlin 206/820
Merlin 1030/3070
Merlin II
Merlin Legend
Mode
C.O.
Line
Page
Port
C.O.
Line