SATO WS208 Technical Manual

Technical Manual WS208 / WS212 WS2-r02-25-03-19TM © 2019 SATO Corporation. All rights reserved. ...

Release Date (Year / Month / Date) WS2_Technical_Manual_ENG_02 P14. Changed the picture of BT module card onto the WS2 P13. Filled in the BT installation procedure and try to update this manual before 3/22. P13. Just wrote (Bluetooth option available depending on region) 2019 / 03 /25 ...

Who should read this manual ................................................................................................ 1 Related Documents ........................................................ ...

installation guides, operating guides, printer setting tool help, network architecture overview and technical drawings. It doesn’t contain programming examples. For more information about printer programming, see related documents. Who should read this manual This manual is ...

Cutter 2 1 Accessories Installation This chapter describes how to install accessories on your printer. 1.1 Cutter A cutter is used to cut the label after it is printed out. Full cutter cuts a label off from a media roll. To install a cutter: Step 1. Remove the base frame This part describes how to dismantle your printer. 1. Open th ...

Cutter 3 This part describes how to thread the cutter cable and connect to the main board. 1. Thread the cutter cable through 2 square holes as below. 2. Plug the cutter connector to J8 as below. 3. Remove interface cover and reinstall the base cover. Put the interface cover back. 4. Secure it with 3 screws. 5. Turn over and lift t ...

Cutter 4 7. Secure the cutter with 2 screws. Step 3. Test the cutter This part describes how to use the cutter to cut your label. 1. Place the media roll between the holders. Make sure the print side is up and the media roll is clamped tightly by the holders. 2. Pull the media until it reaches out of your printer. Thread the media ...

Peeler 5 1.2 Peeler A peeler automatically removes the liner from the printed label. The peeler sensor detects if a peeled label is taken away. To install a peeler: Step 1. Remove the base frame This part describes how to dismantle your printer. 1. Open the top cover and Remove tear bar. 2. Turn over your printer. 3. Loosen and rem ...

Peeler 6 2. Plug the peeler connector to J14 as below. 3. Put peeler in the printer and align two side of hole. 4. Insert shaft to two align hole from left to right. ...

Peeler 7 5. Adjust shaft position to make sure notch exceed printer module. 6. Use sharp nose pliers to fix shaft with E Ring on both side. 7. Remove interface cover and reinstall the base cover. Put the interface cover back. 8. Secure it with 3 screws. 9. Turn over your printer and open top cover. 10. Insert peeler bar to the gap ...