Openplan C-LEG GRADE 1 BASE Assembly & Use

Text of Openplan C-LEG GRADE 1 BASE Assembly & Use

www.openplan.com | 844.OPS.OPS1 | [email protected] | REV 09.12.17

1 C-LEG GRADE 1 BASE POWERED ADJUSTABLE HEIGHT TABLE A SSEMB LY & USE
www.openplan.com | 844.OPS.OPS1 | [email protected] | REV 09.12.17 2 SAFETY INFORMATION USE & LIABILITY
www.openplan.com | 844.OPS.OPS1 | [email protected] | REV 09.12.17 3 ASSEMBLY Note: Instruction diagrams show a T-Leg style instead of the standard C-Leg style for the Deluxe Base.
www.openplan.com | 844.OPS.OPS1 | [email protected] | REV 09.12.17 4 ASSEMBLY Note: Instruction diagrams show a T-Leg style instead of the standard C-Leg style for the Deluxe Base.
www.openplan.com | 844.OPS.OPS1 | [email protected] | REV 09.12.17 5 ASSEMBLY Note: Instruction diagrams show a T-Leg style instead of the standard C-Leg style for the Deluxe Base.
www.openplan.com | 844.OPS.OPS1 | [email protected] | REV 09.12.17 6 ASSEMBLY USE TROUBLESHOOTING SPECIFICATIONS Open Plan Systems at 844.OPS.OPS1 or by email at [email protected] Open Plan Systems
www.openplan.com | 844.OPS.OPS1 | [email protected] | REV 09.12.17 7 Setting the upper/lower limitS The base is designed to go to its minimum and maximum heights, allowing for the widest possible range. If you prefer to change the settings to a more narrow range, follow these steps: Make sure the power is ON and a number reads in the LED display (if no number appears, please follow the Reset procedure.) To Set the Upper-Limit Position: Use the UP/DOWN but
www.openplan.com | 844.OPS.OPS1 | [email protected] | REV 09.12.17 8 Setting the led diSplay retracted height Press the DOWN button on the Switch until the base reaches its lowest position. Measure the height of the base from the floor and if the number on the LED display does NOT match your measurement, follow these steps: Press and hold the DOWN button again until the LED display reads “RST”. Press and hold the “M” button (about 5 seconds) until

Openplan Indoor Furnishing Owners Instructions: