OTT PLS Supplement To Operating Instructions

Text of the manual

Table of contents

1 Scope of supply 4 2 Order numbers 4 3 Introduction 5 4 Please note – important information 5 5 Separating/inserting plug-in connection 5 6 Information on repair 7 7 Technical Data 7

1 Scope of supply

 – 1 pressure probe with ceramic, capacitive relative pressure measuring cell and plug-in, shielded, pressure probe cable with pressure compensation capillary and Kevlar core for length stabilization. Pre-fabricated cable end with trans- port protection against moisture. Optionally with 4 … 20 mA or RS-485 inter- face (SDI-12 protoco

The "OTT PLS plug-in type" is equipped with a plug-in pressure probe cable, in

contrast to the standard model. In the case of damage to the device, the pressure probe can thus be replaced more easily and deinstalling the pressure probe cable is not necessary. In the same way, during the initial installation, first the pressure probe cable (wit

Pressure probe cable

O-ring Pressure probe Connector (connector sleeve on connector body) Protective cap Coding lug Protective cap Caution: There must not be a gap here when connected and screwed together (as far as possible)! Caution: Avoid the entry of damp and contamination when disconnected! Put on protective caps! Coding lug

How to join the plug-in connection:

 If necessary: dry and clean the connector, pressure probe and protective cap*.  Take the protective cap off the connector and the pressure probe.  Check the O-ring on the pressure probe for damage and correct seating. Replace O-ring if necessary* (spare part - temporarily cover the thread with adhesive tape before repl

OTT Hydromet GmbH

Ludwigstrasse 16 87437 Kempten · Germany Tel. +49 831 5617- 0 Fax +49 831 5617- 209 [email protected] · www.ott.com Document number 63.037.002.B.E 02-0511

Other Measuring Instruments Manuals