OTC 4246 Instructions Manual

Text of OTC 4246 Instructions Manual

Explanation of Safety Signal Words

The safety signal word designates the degree or level of hazard seriousness. DANGER: Indicates an imminently hazardous situation which, if not avoided, will result in death or serious injury. WARNING: Indicates a potentially hazardous situation which, if not avoided, could result in death or serious injury. CAUTION: Indicates a potentially hazardous situation which, if not avoided, may result in minor or moderate injury.

WARNING: To prevent personal injury and/ or property damage,

• Study, understand, and follow all safety precautions and operating instructions before using this Hendrickson Rear Suspension Bushing Tool. If the operator cannot read instructions, operating instructions and safety precautions must be read and discussed in the operator’s native language. • Only qualified operators may install, operate, adjust, maintain, clean, repair, inspect, or trans

Pivot Bushing Removal

1. Insert the adapter pin through the alignment tool and into the pivot bushing hole as shown in Figure 1. 2. Place the clamping plate over the alignment tool. 3. Assemble the clamping nuts to the threaded rods. 4. Insert a threaded rod through the upper holes in the clam

8. Thread the cylinder into the cylinder mounting plate. See Figure 3.

WARNING: To prevent personal injury, the cylinder must be fully threaded into the cylinder mounting plate. 9. Install the cylinder mounting plate onto the end of the threaded rods. Adjust the clamping nuts as needed to fit the threaded rods through the holes in the cylinder mounting plate. Assemble the hex nuts on the threaded rods. Tighten the hex nuts on both ends of the threaded

Pivot Bushing Installation

1. Clean and thoroughly lubricate the entire surface of the inside diameter of the beam and the outer diameter of the bushing. See Figure 4. 2. Insert the adapter pin into the head of the cylinder. 3. Place the pivot bushing on the end of the adapter pin as shown in Figure 4. 4. Operate the pump to extend the cylinder piston and apply enough pressure to hold the tool and components. Check the alignment of the pivot bushing. WAR

(52K or 46K)

Remove 4 4 4 Install 4 4 4 D-Pin Removal 1. Mark the beam to show the alignment of the existing D-pin. Install the alignment tool over the D-pin, and place the clamping plate over the alignment tool. See Figure 5. 2. Assemble the clamping nuts to the threaded rods. 3. Insert a threaded rod through the upper holes in the clamp

7. Thread the cylinder into the cylinder mounting plate. See Figure 7.

WARNING: To prevent personal injury, the cylinder must be fully threaded into the cylinder mounting plate. 8. Install the cylinder mounting plate onto the end of the threaded rods. Adjust the clamping nuts as needed to fit the threaded rods through the holes in the cylinder mounting plate. Assemble the hex nuts on the threaded rods. Tighten the hex nuts on both ends of the threaded

1. Clean and thoroughly lubricate the entire surface of the inside diameter of the beam and outer bushing.

See Figure 8. 2. Insert the saddle into the head of the cylinder. 3. Assemble the new D-pin and the D-pin adapter as shown. Align the line in the D-pin adapter with the alignment marks made during the removal procedure. 4. Operate the pump to extend the cylinder piston and apply enough pressure to hold the tool and components. Che

Pivot Bushing Removal

1. Insert the adapter pin through the alignment tool and into the pivot bushing hole as shown in Figure 9. 2. Insert the bushing support over the pivot bushing. 3. Assemble the clamping nuts to the threaded rods. 4. Insert a threaded rod through the upper holes in the

OTC Tools Owners Instructions: