PaloAlto Networks PA-5200 Series Hardware Reference Manual

© 2019 Palo Alto Networks, Inc. STEP 5 | After all DC power cables are securely connected, power on the DC power source. ...

© 2019 Palo Alto Networks, Inc. Connect AC Power to a PA-5200 Series Firewall The following procedure describes how to connect AC power to a PA-5200 Series firewall with AC power supplies. To avoid injury to yourself or damage to your Palo Alto Networks® hardware or the data that resides on the hardware, read the Product Safety Warnings. STEP 1 | Remove the two nuts and star washers from the ground studs on the back of the firewall and then remove the two-hole ground lug. STEP 2 | Crimp ...

© 2019 Palo Alto Networks, Inc. Product Safety Warnings To avoid personal injury or death for yourself and others and to avoid damage to your Palo Alto Networks hardware, be sure you understand and prepare for the following warnings before you install or service the hardware. You will also see warning messages throughout the hardware reference where potential hazards exist. All Palo Alto Networks products with laser-based optical interfaces comply with 21 CFR 1040.10 and 1040.11. The following safety warnings apply ...

© 2019 Palo Alto Networks, Inc. STEP 5 | Remove the replacement drive from the packaging, determine the drive model, and place it on an antistatic surface. Then compare this model number with the model number of the failed drive to determine which replacement procedure to use in 7. STEP 6 | Install the replacement drive in the drive carrier. 1. Place the failed drive next to the replacement drive with the connectors facing the same direction. 2. Remove the four screws that hold the failed drive ...

Statements Overview © 2019 Palo Alto Networks, Inc. ...

© 2019 Palo Alto Networks, Inc. Replace a Drive on a PA-5200 Series Firewall The PA-5200 Series firewalls have two solid-state drives (SSDs) used for system files and system logs and two hard-disk drives (HDDs) used for network traffic log storage. Each drive pair is in a RAID 1 array so that if a drive fails, you can replace the failed drive (using the same model drive) without service interruption. The system drives are labeled SYS 1 and SYS 2 and the log drives are labeled LOG 1 and LOG 2. Wh ...