Waveshare Pan-Tilt HAT Operation & User’s Manual

Text of the manual

Pan-Tilt HAT User Manual

Version: V1.0.0; Date: 2019.03.16 1 / 17 Pan-Tilt HAT User Manual OVERVIEW This is a 2-DOF pan-tilt kit designed for Raspberry Pi. With onboard PCA9685 PWM chip and TSL2581 ambient light sensor, it allows the Pi to control camera movement and sense light intensity through I2C interface. SPECIFICATION Operating voltage: 3.3V/5V PWM

Pan-Tilt HAT User Manual

Version: V1.0.0; Date: 2019.03.16 2 / 17 CONTENT Overview ........................................................................................................................................................1 Specification ............................................................................................................

Pan-Tilt HAT User Manual

Version: V1.0.0; Date: 2019.03.16 3 / 17 HARDWARE CONTROLLER The PWN driver is PCA9685, an I2C-bus controlled 26-channel LED controller, 12-bit resolution PWM output. Pan-Tilt HAT integrate TSL2581 on board. TSL2581 is a light sensor, can be used to detect light and work with camera. TSL2581 use I2C interface as well. COMMUNICATION

Pan-Tilt HAT User Manual

Version: V1.0.0; Date: 2019.03.16 4 / 17 When working, Raspberry Pi (hereafter named as Master) will first send a Start signal, then send a byte to TSL2581 (hereafter named as Slaver), whose first 7bits are address of Slaver and 1 bit write bit. Slave response with Answer signal every time it receives any data. Master send command r

Pan-Tilt HAT User Manual

Version: V1.0.0; Date: 2019.03.16 5 / 17 Note: The default I2C address pins are set as A5=A4=A3=A2=A1=0, address is 0x40. I2C address pins are set as Float and its I2C address is 0x39 by default. If you use the module with other development board, please add R/W bit to Low bit HOW TO USE This part shows you how to use the module bas

Pan-Tilt HAT User Manual

Version: V1.0.0; Date: 2019.03.16 6 / 17 EXAMPLES DOWNLOAD EXAMPLES TO RASPBERRY PI You can download the demo code from wiki, uncompressing and copy to Raspberry Pi, or directly clone it from github: Open terminal of Raspberry Pi and download it: git clone https://github.com/waveshare/Pan-Tilt-HAT Change it execute permission and en

Pan-Tilt HAT User Manual

Version: V1.0.0; Date: 2019.03.16 7 / 17 sudo make check sudo make install Note: The xx is the version number you download, for example, if the version you download is bcm2835-1.52. then the command you should execute is sudo tar zxvf bcm2835-1.52.tar.gz wiringPi libraries: sudo apt-get install git sudo git clone git://git.drogon.ne

Pan-Tilt HAT User Manual

Version: V1.0.0; Date: 2019.03.16 8 / 17 ASSEMBLY Note: Before you assemble servos to Pan-Tilt HAT, please test the servo with test codes to avoid of servo stuck when rotate 1. Connect servos to Pan-Tilt HAT Brown wire GND Red wire 5V Yellow wire S1/S0 You should connect the Pan servo (close to HAT board) to S1, and connect Tilt ser

More Waveshare Camera Accessories Owners Instructions: