PoS Tektronics PS2000 Programming Manual

Text of the manual

5 - 1.Device selection

5 - 2.Function code selection .................. 5 - 3.Language ........................... 5 - 4.Scancode delay 6.RS - 232C setting 6 - 1.Baud rate 6 - 2.Parity 6 - 3.Data bits 6 - 4.Sto

1. Getting started

Installing a Keyboard Wedge Scanner ①Make sure that the scanner has the correct cable for your system. ②Turn off the power of the system. ( or PC ) ③Unplug the keyboard from the system. ④Connect Y cable to the system and keyboard. ⑤Turn on the power of the system. If the indicator LED lights up, Buzzor sounds, the sca

2. Setup procedure

The general procedure to program is as follows. ①Scan the command symbol "Program". ②Scan one or more parameters. ③Scan the command symbol "End" to close procedure. Example 1. To set the RS 232 parameters to 9600,N,8,1 (Page 7~9) ①Scan the barcode "Program". ②Scan "9600" "N" "8" "1". ③Scan "End". Example 2. To set additional di

6. RS-232C setting

6 - 1. Baud rate 5 - 4. Scancode delay Ex ) If scanner needs 15ms of delay, scan "Program" "AT Delay" "1" "5" "AT Delay" "End".

6 - 5. Hand shaking

Ex ) If delay time of 30ms is required, scan "Program" "Wait timeout" "3" "0" "Wait timeout" "End".

Other Barcode Reader Manuals