three h UPSIDE Assembly Instructions Manual
Text of three h UPSIDE Assembly Instructions Manual
GENERAL ASSEMBLY INSTRUCTIONS · SIZES MAY VARY
1
2
DESK TOP AND LEGS
LEG SECURE
Place desk top good side down on a clean
soft surface.
Place legs in position as shown.
Secure legs in place using 6 M6x16mm flat
socket cap bolt provided for each leg.
UPSIDE
Pg. 1
GENERAL ASSEMBLY INSTRUCTIONS · SIZES MAY VARY
1
2
DESK TOP AND LEGS
LEG SECURE
Pla
GENERAL ASSEMBLY INSTRUCTIONS · SIZES MAY VARY
3
4
5
LEG PLATES
POWER
INITIALIZATION
Place bottom leg plates in position and
secure in place using 4 M6 x16mm flat
socket cap bolts provided for each plate.
Once the legs are secured in place and the
leg base plates are fasten securely, plug
the power cords into the legs.
Turn desk to upright posi
GENERAL ASSEMBLY INSTRUCTIONS · SIZES MAY VARY
Page 5 of 28
Safety instruction
General
Important information
Important information on LINAK® products can be found under the
following headings:
Warning!
Failure to comply with these instructions may result in accidents
involving serious personal injury.
Failing to follow these instructions can r
GENERAL ASSEMBLY INSTRUCTIONS · SIZES MAY VARY
Page 6 of 28
Before installation, re-installation, or troubleshooting:
• Stop the DL5/DL6
• Pull out the mains plug.
• Relieve the DL5/DL6 of any loads, which may be released during the
work.
Before start-up:
• Make sure that the system has been installed as instructed in this User
Manual
GENERAL ASSEMBLY INSTRUCTIONS · SIZES MAY VARY
Page 8 of 28
Repairs
In order to avoid the risk of malfunction, all DESKLINE® repairs must only be carried out by authorised LINAK
workshops or repairers, as special tools must be used and special gaskets must be fitted. Lifting units under
warranty must also be returned to authorised LINAK worksh