Aube Technologies TH109PLUS Owner's Manual

Overview About your new thermostat ................................................................................... 1 Controls and display.............................................................................................. 2 Installation Installation guidelines........................................................ ...

baseboard heater, a convector or a fan-forced heater. The thermostat CANNOT be used with: • a resistive load under 2 A • a resistive load over 12.5 A • a system driven by a contactor or a relay (inductive load) • a central heating system SUPPLIED PARTS • One (1) ...

2 Controls and display Backlit Screen Up button Temperature Heating intensity indicator (the image disappears when heating is off) Appears when the setpoint is displayed Appears when the thermostat is configured for a fan-forced heater (see page 6) The settings are locked (see page 6) Down button ...

PANEL TO AVOID ELECTRICAL SHOCK.  The installation must be performed by a qualified electrician and must com- ply with electrical codes of your region.  Do NOT install the thermostat in an area where it can be exposed to water or rain.  Avoid locations where there are air drafts (such as t ...

4 n Loosen the screw underneath the thermostat and separate the faceplate from the wallplate. NOTE: The screw remains captive and cannot be completely removed. o Wire the thermostat (see page 5). p Mount the wallplate to the electrical box using the provided screws. Insert the screws through the two left or right mounting holes ...

to the power supply. Wiring 2-wire Installation 4-wire Installation ...

6 Configuration switches are on the back of the faceplate. Factory settings are inside gray cells. 1 The thermostat buttons are disabled and appears on the screen (see page 2) when the settings are locked. 2 Place at Fan Yes if you have a fan-forced heater (to prevent premature burn- out of the motor). Leave at No for better te ...

• To display the set temperature (setpoint), press the Up or Down button once. The setpoint temperature will remain on the screen for 5 seconds. • To change the setpoint temperature, press the Up or Down button repeatedly until the desired temperature is displayed. • The screen is back ...

8 n Press the Up and Down buttons simultaneously for three seconds to enter the setup menu. o Press the Up or Down button to change the option. p Press the Up and Down buttons simultaneously and briefly to advance to the next parameter. q When the last parameter is displayed, press the Up and Down buttons for three seconds to sa ...