Audio Technica AT-LP60 Installation And Operation Manual
Text of the manual
AT-LP60 Automatic Stereo Turntable System
Installation and Operation Pages 2-8
AT-LP60
Système de tourne-disque stéréo automatique
Installation et utilisation Pages 9-15
AT-LP60
Sistema tocadiscos estéreo automático
Instalación y funcionamiento Páginas 16-22
Automatic Stereo Turntable System
2
Introduction
Thank you for purchasing the AT-LP60 automatic stereo turntable
system. Audio-Technica has been a leading manufacturer of innovative
stereo phonograph products for more than 40 years. We are pleased
to provide this turntable, with its excellent performance and many
convenient features, for your enjoyment.
The
Engages the motor/platter and begins automatic operation.
2.
STOP BUTTON
Disengages the motor/platter and returns tone arm to rest.
3.
TONE ARM LIFT BUTTON
Lifts and lowers tone arm for manual selection.
4.
PLATTER SPEED BUTT
Assembling the Turntable
The AT-LP60 requires some assembly before first use. IMPORTANT:
Do not connect the AC power cord until assembly is complete.
1.
Carefully place the turntable platter on the center spindle,
making certain the platter is fully seated on the spindle.
2.
While holding both ends of the red tape ribbon on the
turntable belt,
Initial Setup (continued)
Operation
Automatic Operation
1.
Remove the stylus guard from the stylus assembly
(Fig. 4).
2.
Put a record on the turntable. If needed, use the
45 RPM adapter (Fig. 5).
3.
Select the size of record: 12" or 7" (Fig. 6).
4. Select the speed: 331/3 RPM or 45 RPM (Fig. 7).
5. Start: Gently push the START button (Fig. 8a).
Replacing the Stylus
While holding the head of the tone arm, rotate the front of the stylus
assembly in a forward and down motion to remove it (Fig. 9). (As you
remove the old assembly, note its position and “feel,” to aid in properly
installing the new one.)
Install the new stylus assembly as shown in Figures 10a/10b, being
careful
Turntable does not operate
1.
Make certain the turntable’s AC cord is plugged into an AC
outlet, and that the AC outlet is “live.”
2.
Check the drive belt to make certain it is on correctly. (See
Figure 11.)
A) Remove the record mat from the turntable platter (Fig. 11a).
Place the mat in the cardboard packaging sleeve for safeke
Tips For Better Performance
Type
Belt drive turntable, fully automatic
Platter
Aluminum
Motor
DC servo-controlled
Speeds
331/3 RPM, 45 RPM
Wow and flutter
Less than 0.25% (WTD) @ 3 kHz (JIS)
Signal-to-noise ratio
>50 dB (DIN-B)
Cartridge
Integral Dual Magnet™ stereo cartridge with diamond stylus
Output level
Pre-amp “PHONO”
2.5 mV nominal at 1 kHz, 5 c
Système de tourne-disque stéréo automatique
Introduction
Merci d’avoir choisi le tourne-disque AT-LP60. Audio-Technica est
depuis plus de 40 ans un leader et un novateur dans la construction de
produits phonographiques stéréo. Nous sommes fiers de vous proposer
ce tourne-disque qui se distingue par ses excellentes performances et
ses nombreuses foncti