Zonar V4 Installation & User Manual

2 Contents Introduction ................................................................................................................................... 5 System Overview .......................................................................................................................... 6 Installation Checklist ........ ...

3 9 Pin Diagnostic 500K Cable .................................................................................................... 17 2-Pin Deutsch 500K Cable (Backbone) .................................................................................... 18 4 Pin, 4 Wire Power Cable .............................................. ...

4 External GPS Antenna (optional) ............................................................................................. 27 V4 and Mount Dimensions ........................................................................................................... 28 Typical Installation ........................................... ...

5 Introduction Zonar equipment will provide years of reliable service if properly installed and maintained. Zonar equipment is typically installed in heavy vehicle applications and is often subjected to extreme temperatures, dust, dirt, vibration, and shock. Proper installation is the critical first step to equipment longevity a ...

7 Installation Checklist The following is an installation checklist broken down by task. Task # Task Required? Page # Complete? 1 Inventory all V4 equipment Required 8 2 Layout all cables and accessories according to: Required - 3 -General guidelines Required 9 4 -V4 device and mounting plate instructions Required 11 5 -Power / ...

8 V4 Equipment A. V4 GPS Unit B. V4 Mounting Plate and Mounting Screws (Provided) C. GPS Antenna (Optional) D. GPS Antenna Adhesive Tag (Optional - used for non-magnetic rooftop GPS Antenna installs) Note: See External GPS for detailed information on GPS antenna requirements and recommendations. ...

9 General Guidelines The following is list of general guidelines for the installation process. It is important to read these before starting. Layout • V4 unit must be located a minimum of 25 cm (10 inches) from any person. • Do not place Zonar RFID tags, cables, or other equipment in any location or position which may compro ...

10 Drill Holes • Do not drill into the V4 unit. This will void the warranty. • Capture all drill chips during drilling operations. Do not allow chips to fall onto equipment, furnishings, etc. • Deburr all drill holes on both sides of drilled surface. The following is an example of a deburr tool: • All drill holes must ha ...