ZIEHL S1 adjustable Operating Manual
Read Online
Read the ZIEHL S1 adjustable Operating Manual online using the built-in PDF viewer.
Key Pages of Document
Daimlerstr.13, 74523 Schwäbisch Hall, Germany + 49 791 504-0, [email protected], www.ziehl.de Temperature Relays and MINIKA® Mains Monitoring Digital Panelmeters MINIPAN® Switching Relays and Controls Measuring Transducers Grid- and Plant Protection Operating Manual S1 adjustable updated: 2019-08-08/Fu S1 adjustable 11800-0702-01 Page 1 / 6 www.ziehl.de - Detection of current flow in a conductor Table o ...
www.ziehl.de 1 General Notes Compliance with the following instructions is mandatory to ensure the functionality and safety of the product. If the following instructions given especially but not limited for general safety, transport, storage, mounting, operating conditions, commissioning and disposal / recycling are not observed, the product may not operate safely and may cause a hazard to the life and limb of users a ...
www.ziehl.de 5 Connecting diagram Connection Plan for output PNP Connection Plan for output NPN Switching Plus, Output 1 Switching Minus, Output 2 - Output 1 and output 2 can be connected at the same time - Load of outputs max. 20 mA - The output in non-short-circuit-proof, short circuit max. 3s - When a current is applied> the adjusted limit, the yellow LED lights and the outputs switches Connection to ZIEHL current- ...
www.ziehl.de 8 Installation The Current Sensor S1 can be mounted on the conductor with 2 screws M3, e.g. at a current bar, or with a cable fastener. Make sure that the conductor is closely led lengthwise along the side of the housing with the latches. The direction of the current is not relevant. The sensitivity depends on the distance from the cable, its diameter and the thickness of the insulation. To avoid crosstal ...
www.ziehl.de electrical Safety IEC/EN 61010-1 Rated insulation voltage Ui 300 V Rated impulse voltage Uimp 4000 V Overvoltage category CAT III Insulation material group I CTI = 600 Pollution degree 3 Reinforced insulation Housing – input/output Insulation test voltage type test AC 3510 V / 50 Hz 60 s EMC emitted interference EN 61326 RF radiated – EN 55011 Class B RF conducted – EN 55011 Class B EMC-tests E ...
www.ziehl.de 1,5 11 82 92 102 16,5 3,2 12 Disposal Disposal should be carried out properly and in an environmentally friendly manner in accordance with legal provisions. 13 Housing Type S1 Dimensions in mm ...
