Sirit INfinity 510 Operation & User’s Manual

i Preface Sirit’s INfinity 510 User’s Guide is designed to allow you quickly install, configure, and operate your reader. This guide only provides instructions for a basic installation and you should refer to the INfinity 510 Developer’s Guide and Protocol Reference Guide for more detailed programming, configu ...

Reader Overview INfinity 510 User’s Guide, P1.04 1 Reader Overview Introduction The INfinity 510 is a multiprotocol, multiregional Radio Frequency Identification (RFID) System that operates in the 860 – 960 MHz UHF band. Figure 1 INfinity 510 UHF Reader As shown in the following figure, this high performance reader supports up to four Tx/Rx a ...

Reader Overview 2 INfinity 510 User’s Guide, P1.04 The INfinity 510 is equipped with four status indicators located on the top of the enclosure. These LEDs provide indication for the following: � Sense – Indicates reader has detected a tag in the RF field. � Transmit – Indicates the reader’s transmitter is operating (RF on). � Fault ...

Reader Equipment Installation INfinity 510 User’s Guide, P1.04 3 Reader Equipment Installation Mechanical Installation Mounting the Reader The INfinity 510 is equipped with two mounting flanges and slotted keyholes that accept three #8 (M4) mounting screws. Predrill any mounting surface according to the following dimensions. Any mounting surfac ...

Reader Equipment Installation 4 INfinity 510 User’s Guide, P1.04 Mounting the Antennas The INfinity 510 supports from one to four antennas in a variety of configurations. One and two-antenna configurations are typical for most conveyor and container tracking. Four-antenna configurations are used for portals and loading dock doorways. The option ...

Reader Equipment Installation INfinity 510 User’s Guide, P1.04 5 Electrical Installation Caution: The INfinity 510 is designed to meet the regulatory requirements in those jurisdictions in which it is offered. Changes or modifications not expressly approved by Sirit Inc for compliance could void the user's authority to operate the equipment. Co ...

Reader Equipment Installation 6 INfinity 510 User’s Guide, P1.04 Connecting the Ethernet Port The maximum Ethernet cable length is 30 meters. If you are communicating with your reader across a Local Area Network (LAN), connect an Ethernet cable from your hub or router to the RJ-45 connection. See Figure 2 for location of the connector. If you a ...

Reader Software Installation INfinity 510 User’s Guide, P1.04 7 Reader Software Installation Installing Reader Configuration Software The INfinity 510 is equipped with a Microsoft Windows PC application called Reader Startup Tool (RST). You can use this application to configure the reader as well as read and display tag data. Install RST 1 To i ...

6 Reader Configuration 8 INfinity 510 User’s Guide, P1.04 Reader Configuration Start RST To start your reader configuration, open the RST application. Open RST 1 From your Windows desktop, select: Start→Programs→Sirit→INfinity510→Reader Startup Tool 2 If this is the first time starting the RST application, you may receive a Windows Securi ...