Zektor Palladia gX Installation Manual

Text of the manual

WHAT IS THE BEST TYPE OF CABLE TO USE?

You can use Cat5e, Cat6 or greater with Zektor products. The minimum cable standard for this system is Cat5e. Slightly greater distances may be achieved by using Cat6, or slightly better still with Cat7, which has stricter shielding requirements and reduces potential cross talk between data pairs. Whichev

A Analog Phono Ports Connect to analog amp

B RS232 Phoenix Ports 0V = Zero volts (GND). TX is signal coming out of matrix (from remote device) RX is signal going into matrix (to remote device). C IR Receiver and Transmitter Ports Use the supplied IR emitters and plug into the ‘IR Out’ ports for the relevant source (i.e HDMI Input 2 will use IR Our

1 CONNECT SOURCE DEVICES

Connect your source devices into the input ports using a High Speed HDMI cable or better (not supplied). It is recommended to connect devices from Input 1 to Input 8, although you can connect them in any order you wish. 2 CONNECT SINKS Sink devices are connected to ports 1-8 via category cable from the Output port t

RENAMING A SOURCE DEVICE

Click on the  display icon, enter a new name and click on Save Changes. This name is used by Voice Services when controlling specific sinks- be careful when naming these if you intend to use voice control to make sure they are pronounceable. Names must be 13 characters or less and cannot be blank, start with or end with a space, c

ACCESSING THE MATRIX WITHOUT

AN INTERNET CONNECTION While this system works best with an active internet connection it is possible to still configure and operate the system without one. However to configure the system from its defaults a local network connection is required. Normal operation of the CEC and IR control systems does not require any network conn

Up to 1080/24p - Frame packing/sequential (Blu-ray)

Interlaced stereoscopic (satellite/cable broadcasts) SUPPORTED AUDIO FORMATS: LPCM 2.0, LPCM 5.1 LPCM 6.1, LPCM 7.1 Dolby Digital 2.0 Dolby Digital 5.1 Dolby Digital EX 6.1 Dolby Digital Plus 7.1 Dolby TrueHD 5.1 Dolby TrueHD 7.1 Dolby Atmos 5.1.2 Dolby Atmos 5.1.4 Dolby Atmos 7.1.2 Dolby Atmo

FROM SMART TV

AND RELAYED TO SURROUND SOUND SPEAKERS AUDIO RETURNED VIA HDBaseT FROM SMART TV AND RELAYED TO CEILING SPEAKERS AV RACK LOUNGE ANALOG AMP BEDROOM CONCEPT WIRING GUIDE CONCEPT WIRING GUIDE DIGITAL AMP INFRARED HDBaseT HDMI SERIAL ETHERNET AU

US: +1 858 748 8250 UK: +44 1202 413610 | [email protected]

12635 Danielson Court Suites 201/202/203. Poway, CA. 92064 www.zektor.com

More Zektor Amplifier Owners Instructions: