RC Groups VLX230C Assembly Manual

Text of the manual

Welcome and thank you for purchasing the VLX230C. I know you are looking forward to flying a rac-

ing drone that can be customized and can deliver efficient air flow, a strong frame, and fantastic flying capabilities. In this manual you will find the instructions that will take you step by step to complete your drone and to start flying! As you a

Please go over this list below. Verify that all objects on this list are

accounted for before building your quad-copter. 7 7 8 8 A B C D Pod Side Plate X 2 Cinch Strap Qt x1 7 8 A B 4 4 5 5 6 6 7 7 8 8 A B C D 3 4 5 6 7 3 4 5 6 7 3 4 5 6 7 4 4 5 5 6 6 7 7 8 8 A B C D Bottom Plate X 1 Top Plate X 1 Limb Plate X 4 Motor Mount Plate X 8 Zip Ties x 2 7 8 A B M3x

Tools and hardware we recommend

Needle Nosed Pliers Phillips- Head Screw Drivers Allen Wrench Set- Metric Hobby Knife Soldering Iron Solder

Bottom Plate Assembly

1 ESC and FC assembly 2 Antenna Assembly 3 Pod Assembly 4 Motor Assembly 5 Main Body Assembly 6 COMPRESSION ISSUES 7 Pod Assembly 8 Pod Assembly 9 Antenna Option 10 Propeller Assembly 11 Ready to Fly 12

What you need for this step

Using M3 x 10 screws, secure the 20mm standoff to the main plate. TIP To save your battery straps, we suggesting lightly sanding the top edges where the bat- tery straps will go. This will help prevent the sharp edge from cutting into the strap. M3 x 10 Screw 20 MM Standoff x 4 x 4 6 7 8 A B 20mm Standoff M3 x 10 Screw 1 Bottom P

What you need for this step

Depending on the Electronic speed control (ESC) that you use, you might have to mount the individual ESC to the limbs of the VLX. However, for this build we are using a 4-in-1 ESC which we will mount to the bottom plate using the 6mm standoffs and M3 x 10 screws. Mount the Flight controller (FC) above the ESC using the 6mm stand-

What you need for this step

Attach the ProSight antenna using the supplied M2.5 hardware to the lower plate as shown. ProSight antenna M2.5 screws M2.5 Locknut x 1 x 4 x 4 6 7 8 M2.5 Screws M2.5 Locknut 3 Antenna Assembly Antenna

What you need for this step

Attach 2, 28mm standoffs with M3 x 10mm screws (As shown in the diagram). Attach the ProSight camera to the side plate using an M2 screw. M3 x 10 Screw M3 Lock nut 28mm Standoff x 4 x 4 x 2 6 7 8 A B 28mm Standoff FPV Camera M3 x 10 Screw 4 Pod Assembly

More RC Groups Quadcopters Owners Instructions: