REXROTH CS 550/150RC Operator's Manual

Table of Contents 1 Panel Controls 3 2 Operation Screen Layout 4 3 Screen Controls 5 3.1 Pause 5 3.2 Blast 5 3.3 Reverse 5 3.4 Change Solid /Prewet Material 6 3.5 Manual Gate Adjustment 6 3.6 Simulated Ground Speed 7 3.7 Error Messages 7 3.8 TOW 3 Boom Anti-icing (DLA) ...

1 Panel Controls Turn knobs clockwise to increase. ...

2 Operation Screen Layout SPNR SALT - - LIQUID1 Spinner Label Spread Width % Spinner Setpoint Spinner Mode Pause Button Solid Name Gate Mode/Solid Rate Gate Position/Conv Set. Conveyor Mode Blast Button Liquid Name Liquid Rate Liquid Setpoint Liquid Mode Reverse Button ...

3 Screen Controls 3.1 Pause Press the Pause button to pause, and press again to resume spreading. 3.2 Blast Press the Blast button to increase the spreading output, and press again to resume regular rate. 3.3 Reverse Press and hold the Reverse button to change the direction of the Auger (an opti ...

3.4 Change Solid/Liquid Material Press the oval button with “SALT- -” text on it to adjust material type. (Note: Vehicle must be stationary) Use the left and right arrows to change. Use the Left and Right to adjust Press the oval button again to confirm and save the selection. Press the oval butto ...

3.6 Simulated Ground Speed This function is available when a truck is stationary. Tap on the ground speed ‘0’, pop up the UP/Dn arrows, press & hold the UP arrow for 5 seconds to enable the simulated ground speed. Use the up and down arrows to adjust speed with an increment of 5. 3.7 Error Messa ...

DLA rate change Left Boom Centre Boom Right Boom DLA Material Truck Status TOW Status 3.8 TOW 3Boom Anti-icing (DLA) If the TOW is configured as 3 Boom Anti-icing (DLA) the SPINNER AND CONVEYOR will be disabled. Note: Only external boom switches are supported for TOW 3Boom Anti-icing operation. To ch ...

4 Symbol Actions All symbols on the right of the screen require a press and hold for >1 seconds. 4.1 Error Log/Diagnostic When the vehicle is stationary press the ‘Gear’ symbol to display most recent error messages. If a hydraulic pressure&temperature sensor is connected both readings will be ...

4.2 UNLOADING Press the ‘Unload’ symbol to enter into unload mode. (Note: The vehicle must be stationary.) Turn the dials until the desired speed is achieved. Press the symbol again and to exit unload mode. Moving the vehicle will suspend the unload process. It will automatically resume when the ...