Rexnord Falk NRT Replacement

Text of Rexnord Falk NRT Replacement

How To Use This Manual

This manual applies to standard Falk Type NRT backstops. This manual provides detailed instructions on oil seal replacement. Use the following Table of Contents to locate required information. Table of Contents Oil Seal Replacement (Cast Iron End Covers). . . . . . . . . . . 1-2 Backstop Removal . . . . . . . . . . . . . . . . . . . .

13. Check seal surface for any damage prior to installing new

seals. Install one seal at a time. Coat both seal outside diameters with Permatex #3 or equivalent sealant. 14. OUTER SEAL — Position the outer seal squarely in the end cover with the garter spring positioned per Figure 3. NOTE: Use seal with smaller outer diameter as outer seal

in the seal case 180° apart. Control the angle of the drill

as illustrated in Figure 5 to prevent damage to the cam. 5. Insert two #10-.750” sheet metal screws into the seal leaving .500” (13mm) of the screw protruding from the seal face. DO NOT drive the screw more than .250” (6mm) beyond seal face or bearing damage may occur (inner seal only). Use a

Rexnord Industrial Equipment Owners Instructions: