Patlite PHC-D08 Operation & User’s Manual
Text of the manual
Table of Contents
Introduction
4
Notice
4
FCC Compliance
4
Product Checklist
4
For safe application, observe the following:
5
Cautionary Notes
5
1.
Part Names and Dimensions
6
1.1. Model Number Configuration
6
1.2. Part Names
6
1.2.1.
Main Unit
6
1.2.2.
AC Adaptor
6
1.3. Outer Dimensional Drawing
7
1.3.1.
Main Unit
7
1.3.2.
AC Adaptor
7
2.
Product Installa
4.1. Setup Test Mode
24
5.
Specifications
25
5.1. General Specifications
25
5.2. Functional Specifications
26
6.
Maintenance and Inspection
27
7.
Replacement Parts
28
8.
Troubleshooting
29
Thank you for purchasing the PATLITE “PHC-D08” (henceforth, written as “this product”) Interface Converter.
Before installation and use, read this manual (henceforth, referred to as “this book”) and follow the cautions and
guidelines presented. In addition, store this manual for future reference when performing maintenance, r
For safe application, observe the following:
The following symbols classifes the following into different catagories and explains the level of harm inflicted if the
cautions are disregarded.
Warning
Indicates an imminently dangerous condition: failure to follow the instructions may lead to
death or serious injury.
Caution
Indicates a potentially
1. Part Names and Dimensions
1.1. Model Number Configuration
PHC-D08
1.2. Part Names
1.2.1.
Main Unit
Number
Name
1
Output Terminal Buss
2
“Clear” Switch
3
“Set” Switch
4
USB Port (Type-B)
5
RS-232C Port (D-sub 9 pin male)
6
Power Supply LED
7
DC Jack
8
Power Supply Output Terminal
1.2.2.
AC Adaptor
Number
Name
1
DC Plug
2
Power Supply Cable
3
1.3. Outer Dimensional Drawing
1.3.1.
Main Unit
1.3.2.
AC Adaptor
49
37
1650
76
(Unit: mm)
117
28
100
(Rubber feet
not included)
(Unit: mm)
2. Product Installation
Caution
Prohibited
• This product is designed for indoor use. Use this product in a location where it is not exposed to
rain and water. Exposure to rain and water may result in failure and electric shock.
• Install this product where the surface is stable and level. If this product is installed in an unstable
location or o
2.2. Terminal Wiring
Warning
Enforced
• Perform wiring work only after turning off power of the equipment to be connected and this product.
There is a risk of internal circuit damage due to short-circuit or electrical shock.
• Screw-less terminal blocks are used in this product; be sure to use wires which characteristics such
as wire type, wire di
Power Supply Output Terminal Wiring
The Power Supply Output Terminal can be used to control an external load when an AC Adaptor is used. When
using the Power Supply Output Terminal, wire in accordance to the directions indicated below.
[Wiring Method]
1.
Use a minus driver to push in the tab of the control unit’s terminal buss slot.
2.
Insert