Renfert Silent TS2 Instruction Manual

Istruzioni d’uso • Instrucciones de servicio Инструкция по эксплуатации • Instrukcja obsługi 操作说明书 • 사용 설명서 Silent TS2 Nr. 2930 0050 / 2930 1050 21-6670 12112015 / A Made in Germany Ideas for dental technology ...

Silent TS2 Nr. 2930 0050 / 2930 1050 ENGLISH Content 1. Introduction .......................................................................................................................2 1.1 Symbols ..........................................................................................................................2 2. Safety ................. ...

1. Introduction 1.1 Symbols In�the�instructions�for�use�and�on�the�unit�itself�you�will�find�these�symbols�with�the�following�meanings: Danger This indicates a direct risk of injury. Consult accompanying documents! Electrical current This indicates a risk of hazard due to an electrical current. Attention Disregarding ...

2.2 Improper Use Fire�promoting,�easily�flammable�or�explosive�materials�must�not�be�extracted�with�the�Silent�TS2. The extraction of liquids, smoldering or burning materials is prohibited. This device is not intended for private, household use. Any�use�other�than�specified�in�these�instructions�is�deemed� ...

2.5.2 Specific Information ► The mains socket on the device is only designed for purposes specified in the operating in- structions. Connecting other devices may cause material damage. ► Before connecting another electrical appliance to the mains socket, switch the unit off. ► Read the operating instructions of the other appliance and comply with ...

3.1.1 Areas of Application In the dental laboratory different areas of application are possible. Depending on the amount of dust to be extracted and the extraction performance available, both suc- tion hoses can either operate together, or if preferred, each tube alternately. Area of application Standard Workbench (WB) Grinding, separating, polishing, ...

3 On / off switch 30 Menu key 31 Self-diagnosis on / off 32 Audible signal on / off 33 Programming dust drawer full 34 Programming start-up threshold 35 Programming shut off delay 36 7 segment display 37 Suction level display 38 Suction hose display 39 Suction hose keys 40 Enter button, save input / display enter button 41 Button / display function bu ...

4. Setting Up 4.1 Unpacking ⇒Remove the device and all the accessories from the delivery package. ⇒Check the delivery for completeness (refer to the “Scope of Delivery” section). 4.2 Setup The�extraction�unit�is�a�free-standing�appliance,�intended�to�be�set-up�on�the�floor�(e.g.�under�the�work- bench). It is po ...

4.5 Installing the Pinch Valves In order to prevent damage during transport, the following parts - pinch valves (15) - suction pipe (16) - holder (20) are not mounted on the device, but will be delivered in a pre-assembled state. ⇒These�must�be�installed�onto�the�device�before�use: ⇒Unscrew the knurled head screw (19, Fig. 4a). � ...

Long suction hoses, tight bends and kinks will considerably reduce the extraction force at the extraction point. If different suction hose lengths are used, the extraction force will be lower at the extraction point with the longer hose. Make sure that the suction hoses are the same length and diameter. Excess hose can be cut to size or laid in a large ...