TechnoKom AutoGRAPH-Mobile Operation & User’s Manual

3 TechnoKom © 2016 Contents Introduction.............................................................................................................................................................4 Version history.......................................................................................................................................................4 Related documentation ..................................... ...

4 TechnoKom © 2016 Introduction This User Manual applies to the AutoGRAPH-Mobile vehicle and personal tracking device (hereafter - tracker) produced by TechnoKom Ltd. It contains installation and connection procedures of the AutoGRAPH-Mobile, as well as its function and control. This Manual constitutes the Operating Rules to be observed to ensure successful operation of the controller and its compliance with TU 6811-005-12 ...

5 TechnoKom © 2016 Software Copyright Notice Products of TechnoKom referred to in this Manual may incorporate software stored in semiconductor memory or other media, copyrights to which belong to TechnoKom or third parties. Laws of the Russian Federation and other countries secure certain exclusive rights of TechnoKom and third parties to the software, which is subjected to copyright, for example, exclusive rights for dist ...

6 TechnoKom © 2016 This section contains important information for effective and safe operation. Please read the information below before using AutoGRAPH-Mobile vehicle and personal tracking controllers. Performance Characteristics AutoGRAPH-Mobile vehicle and personal tracking controllers operate using a GSM/ GPRS module and function as a low power receiver and transmitter. When the tracker is ON, it receives and transmit ...

7 TechnoKom © 2016 • Australian Communications Authority Radiocommunications (Electromagnetic Radiation - Human Exposure) Standard 1999 (applicable to wireless phones only). In order to ensure the best communication quality and compliance with the safety standards stipulated by the abovementioned documents, the equipment operating rules must be followed. Electromagnetic Interference and Compatibility Almost any electron ...

8 TechnoKom © 2016 Basic Information The «AutoGRAPH-Mobile» (GLONASS/GPS) personal tracking controller is a portable autonomous electronic unit which tracks all movements of assets by recording the time and the route in the form of geographic coordinates received from the satellites of global navigation system GPS (NAVSTAR) or GLONASS. In addition to coordinates, the tracker records a number of other parameters: speed, d ...

9 TechnoKom © 2016 Technical Specifications Description AutoGRAPH-Mobile GPS/GLONASS Receiver Receiver type uBlox MAX-M8Q Supported GNSS GPS + GLONASS / GALILEO / Beidou Channels 72 Autonomous A-GNSS Yes Differential GPS (DGPS) SBAS (WAAS, EGNOS, MSAS, GAGAN, QZSS), RTCM Position accuracy when using GPS/GLONASS GNSS1: • Horizontal (typ.), m • Velocity (typ.), m/s 2.00 (50%) 0.05 (50%) Time to first fix1, s 26 Type of ...

10 TechnoKom © 2016 Description AutoGRAPH-Mobile Charging temperature, °С 0…+45 Dimensions, mm 92 х 58 х 22 Weight (with battery), g 90 1 With nominal signals level -130 dBm. 2 A wide specified range is supplied as the position accuracy when using LBS depends on base stations location around asset. ...

11 TechnoKom © 2016 Components of AutoGRAPH-Mobile 1. GSM LED (orange). 2. GPS / GLONASS antenna placement. 3. NAVIGATION/CHARGING LED (bi-colour). 4. SOS button. 5. Fastening screw (x4). 6. POWER button (hidden). 7. Manufacturer’s label. 8. Mini USB connector. ...

12 TechnoKom © 2016 Getting Started Before turning on the tracker, it is recommended to insert the SIM cards and charge the battery. Installation of SIM-cards The AutoGRAPH-Mobile is equipped with a dual SIM holder. Do a test of a new SIM card in a cell phone before you install it into the controller. This ensures that GPRS / SMS / USSD services are enabled and operate properly, the PIN code matches the code preset in the ...

13 TechnoKom © 2016 Inserting the battery The AutoGRAPH-Mobile comes with a rechargeable Li-Ion battery. The trackers are supplied with batteries of 1800 mAh capacity. To insert the battery: • Unscrew the four fastening screws and remove the back cover of the tracker. • Remove the PCB from the case. • Connect the battery to the Power connector located on the rear of the PCB (see fig.1). • Insert the PCB back in ...

14 TechnoKom © 2016 Charging the battery Before turning on and starting use of the AutoGRAPH-Mobile, it is recommended to charge the battery. The AutoGRAPH-Mobile comes with the USB power adapter and a USB cable (USB AM – USB miniB 5pin) for charging the battery from an electrical mains of 220 V or from a PC. To charge using the USB power adapter: 1. Connect the small end of the USB cable to the USB-mini connector of the ...

15 TechnoKom © 2016 Switching on Before switching on, insert SIM cards into the tracker and connect the battery. To switch the tracker on: • Press the POWER button for a few seconds; • As soon as the POWER LED turns on, release the button. • The POWER LED is located above the POWER button. When the back cover is removed it is easy to see the LED flashing. If the back cover isn’t removed, the LED can be seen thro ...

16 TechnoKom © 2016 AutoGRAPH-Mobile Functions Coordinate acquisition In normal mode, the AutoGRAPH-Mobile acquires coordinates of the asset after the specified period and records the coordinates into FLASH memory. When turning on the tracker for the first time, it can take up to 26 seconds to acquire the position. The acqui- sition time depends on how clear the view of the sky is and for the best performance, it is recomm ...

17 TechnoKom © 2016 multiple messages, which can cause data loss if one of the messages isn’t delivered to the customer. If coordinate acquisition is unavailable using the GNSS, the tracker will determine its approximate GSM localization. As soon as the coordinates are available, the device will send them to the customer. To send data to a preset server The tracker can be set up to transfer the collected data to a preset ...

18 TechnoKom © 2016 AutoGRAPH-Mobile Operation Modes To save battery resources, AutoGRAPH- Mobile can be configured to switch to Sleep mode when an asset is not moving or external power of AutoGRAPH-Mobile is turned off. The events forcing the device to switch to Sleep mode can be easily set up by remote configuration commands or in the MobileConf program. When the device is in Sleep mode, main functional modules of the de ...

19 TechnoKom © 2016 Tracker Indicators The AutoGRAPH-Mobile has two LEDs intended to indicate the device operation. Install SIM cards, connect the battery and turn on the tracker. The tracker will be ready to operate after location acquisition and connecting to a GSM network. Indication of GNSS receiver operation Location data is not available – NAVIGATION / CHARGING LED (bi-colour) flashes green twice a second. Searchin ...

20 TechnoKom © 2016 Drivers Installation This section covers the installation procedure of the AutoGRAPH-Mobile tracker drivers. Fig.1. 5. Browse to the location where the drivers are saved (Fig.3). 6. Install the driver. When the driver is installed the system will automatically identify connected device (Fig.4). 7. Install drivers for the AutoGRAPH CDC device following the outlined instruction. The AutoGRAPH-Mobile drive ...