Tador CD-200 Installation Manual

● Codeline CD-200 – Surface Mount ● Codeline CD-200-AV – Flush Mount ● Adapter AR-200 – Surface Mount Tador Technologies LTD Amagshimim 18, Qiriat Matalon Petach Tikva, 49170 Israel Phone: +972-3-9226351 Fax: +972-3-9210461 www.tador.net ©2000 Tador Tec ...

2 General: The CD-200-SET system is an access control system for private houses. The system includes an entrance encoder "CD-200" and a telephone line adapter unit. The system enables speaking with visitor who is waiting at the door or the entrance gate, using any telephone in the house including wireless. The electric entrance ...

3 Remark: in order to install DR-200 panel instead or in addition to the CD-200 refer to "DR-200-SET: Adapter and panel user guide". Connect the following wires to the adapter’s terminals. You can assist the attached diagram on page 4. 1,2. 12VAC – verify the power supply is not connected to the power outlet. Pair of wires f ...

4 When speaking with the panel – illuminates constantly. When no conversation – turned off. Microphone and speaker volume adjustments The CD-200 unit leaves the manufacturer site adjusted. Sometimes because of the location (opened or closed space), acoustical problems occur. If the panel’s speaker sound level is too high ...

5 Programming: 100 memory cells up to 6 digits long each one, available. Cell 00 is used for door opening times values storage. Cell 99 is used for programming code value storage. The cells from 01 to cell 70 are used for different access codes values storage. Code length is minimum 2 digits and ,maximum 8 digits. (programming c ...

6 now the following sequence should be entered: memory cell number to cancel(2 digits), and ֠ ֠ ֠ ֠ ֠ ֠ ֠ ֠ confirm with *. For example: canceling the code stored in cell number 01: press the following sequence: ⇒123456 *, 01 *. To finish press: ֠ ֠ ֠ ֠. Setting opening times values A different opening time value ...

7 Operation Calling at the door Press the Bell ֠ ֠ ֠ ֠. A short tune will be sound, wait for vocal answer. If authorized, the lock will buzz for 3 seconds, and you may enter. Opening the lock using the keyboard Enter the access code confirm with *. The lock will be open for the time value it was programmed. Each key stroke i ...