Prestige APS 650 RS Installation Instructions Manual

Installation Instructions For installation in vehicles with 12 volt negative ground circuits, gasoline engines, with automatic transmission only! Model APS 650 RS Installation Manual KIT CONTENTS (1) Remote Start Control Module (2) 3 Button RF Keychain Transmitters (2) Wiring Harnesses (1) Parts Bag Containing (2) Fuses (2) Fuse ...

in safety features, it must not be installed into vehicles with manual transmissions. Doing this can cause serious personal injury and property damage. IMPORTANT ! DO NOT PLUG THE SIX PIN MAIN POWER HARNESS OR THE 12 PIN INPUT / OUTPUT HARN ...

Connect this wire to the accessory wire from the ignition switch. This wire will show +12 Volts when the ignition key is turned to the “ ACCESSORY “ and “ RUN or ON “ positions, and 0 Volts when the key is turned to the “ OFF “ and “ START or CRANK “ positions. WIRING CONNECTIONS: 12 Pin Input / Output Harness B ...

TOWARDS VATS MODULE TO FUSED +12 VDC BATTERY SOURCE MATCHING RESISTOR VATS WIRE #1 (CUT) TOWARDS IGNITION SWITCH 87 87a 85 86 30 VATS WIRE #2 l LIGHT BLUE IGN.3 WIRE FROM REMOTE START MODULE DARK GREEN Wire: Tach Sensor Input This wire will continually monitor the tach rate while the engine is running under power supplied by the ...

In this application, the red wire provides a ground pulse or the pulsed ground lock output. Connect the red wire to the wire that provides a low current ground signal from the factory door switch to the factory door lock control relay. In this application, the green wire provides a pulse ground unlock output. Connect the gre ...

The APS 650 RS Remote Car Starter will learn the tach rate of the vehicle. To learn tach; 1. Start with the programming switch in the OFF position. 2. Turn the ignition key to the ON position. 3. Flip the program switch ON - OFF - ON - OFF - ON - then OFF. 4. Immediately turn the ignition key OFF. 5. Flip the program switch ON, then ...

1. Select a desired mounting location for the program switch and the control switch. The switches may be mounted in or below the dash by drilling a 1/4" dia. hole. Be sure to check behind the dash for adequate clearance for the body of the switch, and to confirm that the drill will not damage any existing components as it passes ...

CONTROLSWITCH TOALARM'SIGNITIONINPUT- (YELLOWWIREOFAUDIOVOXALARMS) LIGHTBLUE WHITE WHITE POSITIVEINHIBIT1 NEGATIVEINHIBIT2 TACH l l l m SPLICE EXISTING BRAKESWITCH IGNITION3 OR SHOCKBY-PASS TOCHASSIS GROUND EXISTINGPARKINGLAMPWIRE SPLICE l PARKINGLAMP BROWNw/BLACK BROWN BLACKw/WHITE CHASSIS GROUND GREYw ...

Modèle APS 650 RS Manuel d’installation Consignes d’installation Télécommande de démarrage d’auto à 3 canaux Ne convient qu’aux véhicules dont la tension de service est de 12 Vcc avec masse négative et équipés d’un moteur à essence et d’une transmission automatique! L’ENSEMBLE COMPREND (1) Module de télécomm ...

ARRÊT ACCESSOIRE MARCHE DÉMARRAGE n n n n FIL VERT PÂLE VENANT DU APS 650 RS FIL JAUNE VENANT DU APS 650 RS Le APS 650 RS est conçu seulement pour les véhicules équipés d’une boîte de vitesses automatique! Même s’il s’agit d’un système hautement perfectionné, doté de nombreuses particularités le r ...