Audiovox 1285264A Owner's Manual

File Specifications

Brand: Audiovox
Category: Security System
Model: 1285264A (Owner's Manual), prrRjzTFIAt4w
File Type: PDF
File Size: 0.24 Mb
Pages: 16 pages

Download Document

Get a high-quality, printable PDF version of this manual for offline use.

Download PDF Manual (16 pages)

⚠️ Download Safety: This PDF is completely safe to download (last scan date: 15/04/2026).

Read Online

Read the Audiovox 1285264A Owner's Manual online using the built-in PDF viewer.

Key Pages of Document

IMPORTANT ! In order to provide you and your vehicle with the highest level of

security, this system is equipped with a dual mode Anti Hi-Jack feature. The selectable Anti Hi-Jack mode and the secured Anti Hi-Jack mode are described in this manual. Having a thorough working knowledge of the operation of both these safety features of your security system will afford you the highest level of personal protection. We urge you to read this manual completely to ...

ARMING THE SYSTEM - ACTIVE

1. Turn off the engine, exit the vehicle, and close all doors, hood lid, and trunk lid. 2. Press and release theARM / DISARM button on the keychain transmitter. þ Red dash mounted L.E.D. begins to flash slowly. þ Parking Lights flash one time. þ Siren sounds one chirp. If the siren sounds 3 chirps, then you have left a door, trunk, or hood lid ajar. Simply close the opened entry point to provide full protection. If the ...

This serves as a visual deterrent to the potential thief. The L.E.D. is a very low current

bulb, and will not cause the vehicle’s battery to drain, even when left unattended for extended periods. þ Whenever the system is triggered, the vehicle’s parking lights will flash for the full 30 second alarm cycle, attracting visual attention to the vehicle. þ Whenever the system is armed, the vehicle’s starting circuit will be bypassed. If the thief should ...

was made to a hood or trunk pin switch that was added to the system, or to a light activated entry

point if the alarm was installed using the voltage sensing feature. If the L.E.D. is flashing three times...pause...three times...pause...etc., then an intrusion attempt was made through one of the vehicle’s doors. These intrusion warning indicators are stored in the system’s memory, and will only be erased when the ignition key is turned on. VALET ...

1. Start with the valet switch in the off position, then turn the ignition key on then off.

2. Within 10 seconds, move the valet switch to on then off three times. 3. If the chirps were on before you started, then you will hear 2 chirps indicating they have been turned off. If the chirps were off before you started, then you will hear one chirp indicating they have been turned on. NOTE : Whenever the chirps are by - passed, the 4 chirp intrusion indicator ...

This initial flashing of the LED allows the operator, if Hi-Jack mode is inadvertently

triggered, the time to disable the Hi-Jack mode before the siren sounds.This is ac- complished by pressing the hidden Anti Hi-Jack override button. Stage 2 For the next 30 seconds in 10 second intervals, the siren will emit a single chirp. The intent of the chirp signals is a warning that the next stage will begin the shut down sequence, first causing the engine to hesit ...

1. Turn off the ignition switch.

2. Press the hidden Hi-Jack enable/override switch one time. The LED turns on for 5 seconds indicating that the secured mode has successfully be entered. 3. Exit the vehicle, close all doors, and arm your security system using the keychain trans- mitter. (Note: the secured Hi-Jack feature will operate with or without the security system armed) While in the secured mode, if the ignition switch is turned on, the APS-25HJ will ...

SYSTEM FUNCTIONS AT A GLANCE

DASH L.E.D. INDICATORS RAPID FLASHING = PASSIVE ARMING SLOW FLASHING = ARMED OFF = DISARMED ON SOLID = VALET MODE 3 FLASH...PAUSE = INTRUSION ZONE 3 2 FLASH...PAUSE = INTRUSION ZONE 2 NOTE: Slow flash while ignition switch is on indicates that the Hi-Jack mode has been triggered. SIREN CHIRP INDICATORS 1 CHIRP * = ARM 2 CHIRPS * = DISARM 3 CHIRPS = ARM / DOOR OPENED 4 CHIRPS = DISARM / INTRUSION * These chirps a ...

Manual del Propietario

Sistema de seguridad con control remoto de 2 botones y función antirrobo en presencia del conductor CARACTERÍSTICAS: w Dos transmisores programables de RF de 2 botones w Receptor de dos canales con captación de código w Salidas negativas pulsadas para el trabado de puertas w Duración seleccionable de la salida del trabado / destrabado de puertas w Trabado controlado seleccionable de encendido (On/Off) w De ...

ACTIVACIÓN DEL SISTEMA - MODO ACTIVO

1. Apague el motor, salga del vehículo y cierre todas las puertas y las tapas del capó y el baúl. 2. Oprima y suelte el botón de ARM / DISARM del transmisor de llavero una sola vez. þ El L.E.D. rojo montado en el tablero de instrumentos comienza a destellar lentamente þ Las luces de estacionamiento destellan una vez. þ La sirena emite un chirrido. Si la sirena emite tres chirridos, entonces ha dejado una ...

visual para un posible

ladrón. El indicador L.E.D. es una bombilla de muy poca corriente que no agotará la batería del vehículo, aun cuando se la deje encendida durante períodos prolongados. þ Cuando se dispara el sistema, las luces de estacionamiento del vehículo destellarán durante un ciclo completo de alarma de 30 segundos, lo que atraerá la atención visual hacia el vehículo. þ Cuando el sistema esté activado, se desviará el circui ...

hubo algún intento de intrusión a través de alguna de las puertas del vehículo.

Estos indicadores de advertencia de intrusión están almacenados en la memoria del siste- ma y solamente se borrarán cuando se encienda la llave de contacto. INTERRUPTOR VALET El interruptor valet le permite anular transitoriamente todas las funciones de la alarma, eliminando la necesidad de entregar el transmisor a los encargados de estacionar coches o los mecán ...

apague la llave de contacto.

2. A los 10 segundos, mueva el interruptor valet a las posiciones de encendido y apagado tres veces. 3. Si los chirridos estaban conectados antes de empezar, entonces oirá un chirrido que le indica que los está desconectando. Si los chirridos estaban desconectados antes de empezar, entonces oirá un chirrido breve que le indica que los está conectando. NOTA: Cuando se desactivan los chirridos, el indicador de intrusi ...

el ajuste de la hora de inicio que está indicado en la última hoja de este manual). El indica-

dor L.E.D. comienza a destellar por 15 segundos. Este destello inicial del indicador L.E.C. le da tiempo al conductor, si se dispara por accidente la modalidad antirrobo, para desactivar la modalidad antirrobo antes de que suene la sirena. Esto se logra apretando el botón oculto de captura manual del sistema antirrobo. Etapa 2 Durante los próximos 30 ...

MODALIDAD FIJA DE FUNCIONAMIENTO

Esta modalidad fija de funcionamiento está disponible, independientemente de que la fun- ción antirrobo esté activada o no. La modalidad fija se usa en aquellos lugares en que el conductor del vehículo sea atacado al volver a su automóvil. Las playas de estacionamien- to de los centros comerciales, las calles oscuras, las entradas a garajes que estén ocultas son lugares típicos en que un ladrón puede ocultar ...

INDICADORES L.E.D. DEL TABLERO

DESTELLO RAPIDO = ACTIVACION PASIVA DESTELLO LENTO = ACTIVADO APAGADO = DESACTIVADO ENCENDIDO CONTINUO = MODO VALET 3 DESTELLOS ... PAUSA = INTRUSION ZONA 3 2 DESTELLOS ... PAUSA = INTRUSION ZONA 2 NOTA: El destello lento mientras la llave de contacto está encendida indica que se ha disparado la modalidad antirrobo. INDICADORES DE CHIRRIDOS DE LA SIRENA 1 CHIRRIDO* = ACTIVAR 2 CHIRRIDOS* = DESACTIVAR 3 CHIRRIDOS = AC ...