Ofil daycor superb Operation & User’s Manual

Text of the manual

POB 4016, Nes Ziona, 74140 Israel

16 Einstein Street, Weizmann Science Park, Nes-Ziona Israel 74000 www.ofilsystems.com [email protected] Tel: +(972)-8-940-7953 Fax: +(972)-8-940-7873 USA Toll free: 1-866-2798672

Table of Contents

CHAPTER 1 ......................................................................................................................................................................... 4 GETTING READY ................................................................................................................................................

U S E R M A N U A L D A Y C O R ® S U P E R B

4 Getting Ready 1. Assemble all accessories so that you have easy access to them 6. Remove the lenses cover 2. Adjust the shoulder straps to fit your body by fastening the straps 3. Fasten the front pad 4. Lean the camera against the front pad. Use the grooves to adjust the viewing angle of the camera. 5.

U S E R M A N U A L D A Y C O R ® S U P E R B

Operating tips * Status Line This function can be turned on/off through the Status function-key. The status line, positioned at the LCD bottom, shows the current status of the display mode, the focus mode, the UV gain, if long-integration is on and the counting value. This data is valuable when processing a

U S E R M A N U A L D A Y C O R ® S U P E R B

6 • Visible only mode • UV only mode • Combined mode While in the UV only mode, the status line displays the UV gain value only . The visible only mode is handy when there is a reflection on glass insulators that might be mistaken for corona. The camera enters the visible only mode during visible zoomi

U S E R M A N U A L D A Y C O R ® S U P E R B

7 LI – Long Integration Long Integration supports inspection of very weak signals or inspection in areas with abundant non-corona UV background signals. This function affects the read-out frequency of frames. Below is an example taken from a distribution line in Costa Rica (a 35 kV line) where a nearby weld

U S E R M A N U A L D A Y C O R ® S U P E R B

8 How to count Enter the counting mode by pressing on the counting function-key. A small frame will appear on the display. By pressing the up and down arrows the size of the frame will change. Position the corona image in the center of the frame and wait until the count value stabilizes with only small fluctu

Other Measuring Instruments Manuals