NGX Technologies LPC185x-Xplorer Operation & User’s Manual

Page | 1 LPC185x-Xplorer++ About NGX Technologies NGX Technologies is a premier supplier of development tools for the ARM7, ARM Cortex M0, M3 and M4 series of microcontrollers. NGX provides innovative and cost effective design solutions for embedded systems. We specialize in ARM MCU portfolio, which includes ARM7, Cortex-M ...

Page | 2 CE certification: NGX Technologies LPC185X-Xplorer++ board has been tested for radiated emission as per EN55022 class a standard. The device is under the limits of the standard EN55022 class A and hence CE marked. No other test have been conducted other than the radiated emission (EN55022 class A standard). The dev ...

Page | 3 Table of Contents 1.0 INTRODUCTION................................................................................................................................. 4 2.0 LPC185X-Xplorer++ Development Tool Setup ................................................................................... 5 2.1 ULINK2/ME and K ...

Page | 4 1.0 INTRODUCTION This document is the User Manual for LPC185X-Xplorer++; a cost effective evaluation platform for NXP’s LPC185x MCU. This document reflects its contents which include system setup, debugging, and software components. This document provides detailed information on the overall design and usage of th ...

Page | 5 2.0 LPC185X-Xplorer++ Development Tool Setup 2.1 ULINK2/ME and KEIL NGX’s MCU evaluation platforms are not coupled tightly with any one particular combination of IDE and debugger. The following sections will explain the setup for KEIL and ULINK2/ME as the IDE and debugger respectively. 2.2 Installation & Configur ...

Page | 6 Step 2: Click on Next. Fig.2 Step 3: To accept the agreement, click the check box and click Next. Fig.3 ...

Page | 7 Step 4: Provide the destination path and click on Next Fig.4 Step 5: Fill your personal information and click on Next Fig.5 ...

Page | 8 Step 6: Click on Next Fig.6 Step 7: Keil µVision4.54 setup is completed, click Finish. Fig.7 ...

Page | 9 2.3 Configuration of ULINK2/ME Debugger The configuration flow of ULINK2/ME Debugger is explained below: Step 1: Open the KEIL blinky project downloaded from the website and click on the ‘Target Options’. Fig.8 Step 2: The window opens as shown in the following image. Next click on Debug and then select the ‘ ...

Page | 10 Fig.9 9 Step 3: Next click on the ‘Settings Option’, the ‘Cortex-M Target Driver Setup’ window opens then select SW port. After selection of the SW port the ULINK2/ME detected is as shown in the following image. Fig.10 (Note: The Cortex M3 can be programming using SW or JTAG.) 2.4 Configuring External Quad ...