Metra Electronics 99-3023HG Installation Instructions

controls panels, and especially air bag indicator lights must be connected before cycling the ignition. Also, do not remove the factory radio with the key in the on position, or while the vehicle is running. Metra. The World’s Best Kits.®� MetraOnline.com © COPYRIGHT 2018 METRA ELECTRONICS CORPORATION REV. 2/16/18 INST99-3023HG INSTALL ATION INSTRUCTIONS 99-3023HG KIT FEATURES • ISO DIN radio provision with pocket • Painted high gloss black KIT COMPONENTS • A) Radio trim panel • B) Radio housing • C) Radio brackets • D) Pocket • E) (8) #8 x 3/8” Phillips screws • F) (4) Panel clips TO ...

2 DASH DISASSEMBLY KIT PREPARATION 1. Unclip and remove the dash panel surrounding the radio. (Figure A) 2. Unclip and remove the radio trim. (Figure B) 3. Remove (2) 9/32” screws securing the radio, then pull down and back to release the radio. Unplug the connectors to remove the radio. 4. Unclip and slide off the plastic trim piece on the top of the radio. (Figure C) 5. Remove (2) 9/32” screws securing each a/c vent, then unclip and remove the vents. Continue to Kit Preparation Please visit Metraonline.com for Dash Disassembly illustrations. Attention! After the sub-dash has been cut, the factory radio will no ...

3 KIT ASSEMBLY 1. Attach the pocket to the radio brackets using the (4) #8 x 3/8” Phillips screws provided. (Figure A) 2. Remove the metal DIN sleeve and trim ring from the aftermarket radio. 3. Slide the radio into the bracket/pocket assembly, then secure it using the screws supplied with the radio. (Figure B) 4. Secure the radio assembly to the radio housing using the (4) #8 x 3/8” Phillips screws provided. (Figure C) 5. Attach the plastic trim piece removed in dash disassembly to the top of the radio housing. 6. Locate the factory wiring harness and antenna connector in the dash and complete all necessary connection ...

Enhance your installation and fabrication skills by enrolling in the most recognized and respected mobile electronics school in our industry. Log onto www.installerinstitute.com or call 800-354-6782 for more information and take steps toward a better tomorrow. ® Metra recommends MECP certified technicians IMPORTANT If you are having difficulties with the installation of this product, please call our Tech Support line at 1-800-253-TECH. Before doing so, look over the instructions a second time, and make sure the installation was performed exactly as the instructions are stated. Please have the vehicle apart and ready to perform troub ...