Cisco TelePresence Server 7010 Installation Manual

Installation Guide 61-0028-06 August 2013 Cisco TelePresence Server 7010 Installation Guide Page 1 of 14 ...

3 Package contents 3 Port and LED locations 3 LED behavior 4 Front panel LED behavior 4 Rear panel LED behavior 4 Connecting the TelePresence Server 6 Before you start 6 Task 1: Connect power 6 Task 2: Connect to Ethernet Port A 6 Configuring the TelePresence Server 7 Task 3: Connect to ...

The Cisco TelePresence Server 7010 (TelePresence Server) is a technologically advanced media processor, combining continuous presence high definition video conferencing and the highest possible voice quality. Package contents The following items are included with the TelePresence Server. Verify tha ...

1000 100 FDX Ethernet B 1000 100 FDX Ethernet C 1000 100 FDX Ethernet D Admin 100 10 FDX Link In Link Link Out Link 1000 100 FDX Ethernet A OK ! Air exhaust Link connectors Power supply Ethernet ports and status LEDs Admin port and status LEDs Power supply latch Protective earth terminals LED behavior Front panel ...

100 Green The link is operating at 100Mbps. This LED flashes to indicate activity 1000 Green The link is operating at 1000Mbps. This LED flashes to indicate activity Admin Port Activity Reserved for future expansion Link Connectors Reserved for future expansion Cisco TelePresen ...

Before you start IMPORTANT: Before installing the TelePresence Server, you must read the safety information at http://www.cisco.com/go/telepresence/safety. Task 1: Connect power Connect the power connector on the rear of the unit to the power supply using the supplied power cable. (There is no On/Off switch.) Task 2: Connec ...

Task 3: Connect to the console port 1. Ensure power is connected to the TelePresence Server and the Status LED is green. A status LED that is not lit indicates the unit is still booting. 2. Connect the console port of the unit to the serial port of your PC using the RJ45 to DB9 cable supplied. 3. Use a serial terminal prog ...

static A 192.168.1.2 255.255.255.0 192.168.1.1 0.0.0.0 n To manually specify a DNS server, use this command: dns [][] n To revert to using DHCP after setting a static IPv4 address, use the following command: ...

Task 8: Configure settings, conferences, and endpoints You may need to configure the network and system settings, then go on to add conferences and endpoints. Refer to the online help for assistance. Cisco TelePresence Server 7010 Installation Guide Page 9 of 14 Configuring the TelePresence Server software ...

It is a good idea to regularly check the Cisco web site for updates to the device's main software. This section describes how to upgrade the device using the web interface. To check for, and download, updates: 1. Log in to the web interface and go to Status > Status. 2. Make a note of the software version that is currently installed. 3. ...