Hideaway Beds Next Bed Single Assembly Instructions Manual
Text of Hideaway Beds Next Bed Single Assembly Instructions Manual
A. Mattress Retainer Bar
- Single Bed (1)
- Double & King Bed (2)
B. Head Frame (1)
C. Center Rail (Double & King Bed)
D. Side Rail (Pair)
E. Leg Actuator Bars (2)
F. End Frame (1)
G. Wall Mount Bracket (2)
H. Floor Yokes (Pair)
I. Yoke Connector Bar (1)
J. Bottom Spring Tube (1)
K. Springs (6-Single, 8-Double and 10-Queen)
L
Insert screws through Wall Mount Brackets (G) and into
Wall and Base Board at a downward angle.
8-3" (76.2mm) Flat Head Screw (8pcs)
Attach the Wall Mount Brackets (G) to the Floor
Yokes (H) using the Bolts, Nuts and
Washers shown below. Place bolt heads on outside.
Do not tighten bolts now so you can adjust later.
M8x20mm Bolt, 2 Flat Washers, Nylock Nut (4
Section 3: BED FRAME ASSEMBLY
Feed one end of each Side Rail (D)
through the loops of the Nylon
Mattress Strap.
- not shown to scale
**Do not attach Leg Actuator Bars (E) at this time**
6.
5.
8.
9.
10.
Slide End Frame (F), Head Frame (B), Side Rails (D)
and Center Rail (C) together as shown.
Attach End Frame (F) and Head Frame (B)
to Side Rails (D); 2 bolts
Section 4: LEG ASSEMBLY
Attach Actuator Bars (E) to the Leg Brackets (N)
with Cotter Pins (see Detail A), then to the Floor
Yokes (H) with Cotter Pins. Bend back ends to secure.
Cotter Pins, Washers (4 sets)
15.
Rotate the bed down horizontal and install the
Slats (Q) by slipping one end into the closed Slat
Holder and flexing the slat slightly and tapping i
Next Bed may be used with or without a cabinet. The cabinet does not attach to the Next Bed mechanism. The cabinet must
be secured to the wall to insure its position relative to the Next Bed frame. Allowances have been made within the interior
cabinet sizes to provide for bed linens to easily be enclosed in the available space.
Listed are the suggested bed c
Notes: A King size Next Bed is two single Next Bed frames bolted together at the foot end with a 0.5”(1.27mm)
plywood spacer between the frames to allow the automatic legs to operate.
If you wish to use a mattress thicker than 12” (30), you must mount the Next Bed frame a greater distance from the
wall by extending the Wall-Mount-Brackets. The cabinet ma