WiMo 18009 Manual 

Text of WiMo 18009 Manual 

Das 'große Rad' ist eine horizontal polarisierte Rundstrahlantenne. Üblicherweise werden im 6m-Band

scharf bündelnde Richtantennen verwendet, die die Möglichkeit bieten, die Strahlungsleistung in einer bestimmten Richtung zu vervielfachen und Empfangsstörungen aus anderen Richtungen auszublen- den. Diese Eigenschaften der Richtantennen sind jedoch nicht immer von Vorteil. Abgesehen von Wochen- enden und Kontesten wird der 6m-Funkverkehr f

- 2 -

Die einzelnen Elementteile werden nun in den Kopf eingebaut, dazu Schrauben M6x35 verwenden, (M6x35/Federring/Aluplatte/Vierkantrohr/U- Scheibe groß/Mutter). Eine „3 Hand“ ist hier sehr hilfsreich ! Die Schraubenköpfe werden immer von außen in den Kopf gesteckt ! Darauf achten das die 3 Teile am „Heißen“ Ende mit dem großen Loch (Durchmesser 12mm) nach rechts, kleines Loch 3mm nach unten, montiert werden. Die 3 restlichen Teile werden an

- 3 -

Jetzt folgt das einsetzen der Rundrohre 10x1 mm, dazu wird der Stab einseitig durch das vorgesehene Loch im Vierkantrohr ge- steckt, 5mm Überstand, noch nicht verschrauben!!, den Stab am anderen Ende nehmen und mit Gefühl in das andere vorgese- hene Loch stecken, (Rohr dabei biegen), zweite Seite bekommt auch 5mm Überstand. Achtung: Darauf achten das die Rohre immer von einem kalten Ende an ein heißes Ende führen (ein Ende an einem UNTEREN Vierk

The big wheel is designed for use together with a yagi system, in order to pick up quickly a signal from

any direction without the need to rotate the yagi array to find a signal from somewhere. It’s a horizontal polarized omnidirectional antenna, when stacking 2 antennas together, you get a antenna with about 5dBD gain. Stacking The ideal stacking distance is about 12 ft. Please take care, the antennas must be mounted exactly in the same way

The single element parts are now screwed

into the antenna head. Use screws M6*35 (M6x35 / lockwasher / plate / square tube / big washer / nut). A third hand will be very helpful. The screws are always put from outside into the antenna head, the nuts are in the gap. Take care: the 3 elements on the ’hot end’ must have the big hole (12mm = 0.5in. diameter) on the right side and the 3mm lower side of the element. The 3 elements on the ‘cold’ side must

Now the 10mm tubes must be assembled. The element joint is

provided with the elements, use screws 2.9*6.5mm provided in a separate screw bag. Take care not to overtighten the screws, some oil will be helpful. Now the long element tubes must be set into the square tubes. Feed the tube on one side into the square tube and bend it carfully and feed it into the other side. The 10mm tube must go trough the square tube on both sides. The end of

WiMo Antenna Owners Instructions: