VARIDESK.com QuickFlex Walls Manual 

Text of VARIDESK.com QuickFlex Walls Manual 

1. STANDARD PANEL SET

• Panel Kit • Post Kit • Upper Panel • Base Plate 2. END PANEL SET (AGAINST EXISTING WALL) • Panel Kit • Post Kit • Upper Panel • Small Base Plate • Post Brace 3. INSTALLING A DOORWAY • Doorless Set • Small Panel Kit • Post Kit • Doorless Stretcher Kit • Small Upper Panel • Base Plate • Door Set • Door Panel Kit • Door Kit 4. ANCHORING TO EXISTING WALL • Top Cap - Wall Anchor 5. ANCHORING TO CEILI

For patent and trademark information, visit VARIDESK.com/patents ©2018 VARIDESK®. All Rights Reserved.

2 People Required x1 x4 x1 x1 x2 x2 STANDARD PANEL SET LOWER PANEL STRETCHER COVER UPPER STRETCHER x1 LOWER STRETCHER UPPER PANEL BASE PLATE POST

Posts come in one box. Make sure the top cap of post is attached, as these can come loose in transit.

Secure the post onto the base plate. Use the included Allen key to tighten both sides of the post into the base. If the post will go up against a wall, make sure to use a small base plate. Refer to next section for installation of end panel. 1 2 2.

Once the first 2 posts are assembled, place them where you want to assemble the first wall section. It’s

important to start building the walls at the highest floor point. There are upper and lower stretchers that insert into posts. Make sure to insert and secure all upper and lower stretchers before placing in any panels. For stability, have one person hold the post while another installs the stretchers. Install the lower stretcher by inserting one side

Check level and connection of stretchers, making sure all stretchers are fully seated and secure before

installing any panels. Base plates can be adjusted to level if necessary. If you’re creating a corner with your panels, you will need to change the position of the side caps to ensure that you can seat and secure your stretchers. All panels should be installed with one person on each side. Align the channel on lower panel with lower stretcher and then

Once all panels are installed, install the stretcher covers on both sides of the upper and lower stretchers.

Align cover with stretcher and slide down to clip in place. To install the upper panel, ensure there is one person on each side of the panel. Similar to the lower panel, align the bottom channel on the top panel with the lower panel and push down until the panel clicks into place. 7 8 5.

For patent and trademark information, visit VARIDESK.com/patents ©2018 VARIDESK®. All Rights Reserved.

2 People Required x1 x4 x1 x1 x2 x1 LOWER PANEL STRETCHER COVER UPPER STRETCHER x1 LOWER STRETCHER UPPER PANEL SMALL BASE PLATE POST BRACE POST END PANEL SET BASE PLATE x1

Posts come in one box. Make sure the top cap of post is attached, as these can come loose in transit.

Secure the post onto the small base plate as close to the wall as possible. Use the included Allen key to tighten both sides of the post into the base. 1 2 7.

For stability, have one person hold the post while another installs the stretchers. Install the lower stretcher by

inserting one side into one post and then the other side into the next post. Push down until it clicks to lock. LOWER STRETCHER Similar to the lower stretcher, insert the upper stretcher into the anchor points at the top of each post. Once in place, pull down until it clicks. Push up on draw latch to secure. Tighten the thread if needed. 3 4 8

VARIDESK.com Indoor Furnishing Owners Instructions: