Rightline Gear 100B90 Setup Manual

Text of Rightline Gear 100B90 Setup Manual

1-Clean the back of your vehicle, unscrew your license

plate, and place it inside the Car Back Carrier’s interior license plate sleeve (Fig 7). 2-Load the Car Back Carrier on the ground. The load capacity of the carrier is 100 lbs. Assemble The Bottom Pole Frame The correct attachment of this product is critical and beyond the control of Rightline Gear. The safe use and long life of this product depends entirely on your good judgment and following these

1-Run the (2) bottom straps through the guides on the bottom

of the carrier (Fig 19) and around the attachment points. The straps’ length can be adjusted by moving the tri-glides. 2-Thread each strap’s end through its buckle (Fig 20) and tighten the (2) straps evenly (Fig 19). Attach The Bottom Straps 3-Move each strap’s tri-glide to the end of the strap’s loose end (Fig 18) so that the strap will not flap in the wind. 1-Buckle the (2) long side st

Rightline Gear Automobile Accessories Owners Instructions: