Hydro EvoWash Operation & User’s Manual

5 1.02 Description (North America vs. Global) 5 1.03 Product Features 5 1.04 Model table 6 1.05 Product Diagram 6 1.06 General Specifications 7 1.07 Intended Use 8 2.OO installation 2.01 Site Survey and Installation Requirements 8 2.10 Mechanical Installation 8 2.11 Installing the Vacuum Breaker (NA only) 8 2.12 ...

20 4.02 Program Mode Menu Settings 20 4.03 Program Mode Menu Trees 21 4.04 Configuration Mode Settings (Program Menu 2) 24 4.05 Probe Mode Adjustment Menu Settings (Program Menu 3) 25 4.06 Probeless Mode Adjustment Menu Settings (Program Menu 4) 26 5.OO maintenance page 5.01 Routine Ma ...

1) EvoWash Dispenser (P/N varies by model, see table on page 6) 3) Accessory Kit (NA P/N HYD10099378, Global P/N HYD10099406) (Pickup Tubing, Detergent Injection Fitting, Conductivity Probe) 2) Mounting Kit (P/N HYD90097975) (Wall Anchors, Screws, Wire Ties and Washers) 4) Rinse Pump Accessory Kit (only w/Rinse Pump) (P/ ...

1.O5 Product Diagram 1. Safety Stop Switch Lever 2. Keyways (Optional) 3. Rinse Pump (Optional) 4. Controls & Display Screen 5. Wiring Conduit Connector (Power & Signals)* 6. Mounting Slots/Holes (x4) 7. Detergent Discharge Fitting 8. Conductivity Probe Cable 9. Water Inlet Fitting 10. Water Y-Strainer 11. Backflow Prevention Vacu ...

1.O6 General Specifications Category Specification Electrical Input Voltage 100-240 VAC at 50/60 Hz up to 0.75 Amps maximum (Class II) Power Usage 12W maximum Detergent Signal Input 24-249VAC at 50/60Hz up to 20mA or 24VDC up to 20mA Rinse Signal Input 24-249VAC at 50/60Hz up to 20mA or 24VDC up to 20mA Weights and Dimensions Glob ...

2.OO installation 2.O1 Site Survey and Installation Requirements • Unit is to be installed by a trained technician; all local and national water regulations are to be observed. • Unit must be installed indoors, in an area that does not suffer excess temperature changes, direct sunlight, frost or precipitation of any kind. • ...

2.12 Installation Diagram Conductivity Probe Wires Detergent Feed Hose Rinse Feed Outlet Hose Rinse Feed Inlet Hose From Rinse product container Water Inlet Dish Machine Power Wires (with fused isolation switch). Detergent and (Optional) Rinse Signal Wires front view side view NOTE: North America Model Shown ...

2.14 Conductivity Probe The probe senses the detergent concentration. Correct probe placement is critical for accurate detergent concentration control. Always use the new probe provided with the dispenser. When choosing a mounting location, make sure that the probe will be completely immersed in wash tank solution, in an area ...