OMP 60” Sbach 342 Manual
Text of the manual
Wing Span: 60 inches
Length: 58 inches
Power: Hacker A50-14S
(or equivalent)
Battery: 3800 5-cell LiPo
ESC: 60-70 amp
Flying Weight: 4.75 - 5.25 lbs
OHIO MODEL PRODUCTS
199 Stratford Lane
Xenia, Ohio 45385
(937) 372-0603
www.ohiomodelplanes.com
email: [email protected]
All contents copyright 2012, Ohio Model Products
Version 2.0, Janua
Models are not insurable but operators are. You can obtain coverage through membership in the
Academy of Model Aeronautics (AMA). For an AMA information package call 1-800-435-9262, ext.
292 or visit the AMA website at "www.modelaircraft.org".
By the act of using the final assembled model, the purchaser/operator accepts
all resulting liability.
OHIO MODEL
Check out these Features:
Carbon Fiber Wing Tube
Carbon Fiber Main Landing Gear
Carbon Fiber Tail Wheel Assembly
Carbon Fiber Reinforced Fuselage
Carbon Fiber Battery Tray
Side Force Generators
Matching painted Carbon Fiber
Spinner
Advanced Ball Links and Pushrods
Extra Ultracote Covering for Repairs
Complete Hardware
1. With all ARFs, varying temperatures and storage delays can cause covering material to loosen over
time and transportation. OMP recommends lightly going over all the covering with a covering iron
set at medium temperatures. Be sure to use a soft cover over your iron so you do not scratch the
covering surface. Be sure you go over all s
3. The hinge slots for the rudder are pre-cut in the rudder and fin. Locate the CA hinges and align them in
the fin. Once aligned and centered in the fin glue in place with thin CA.
LANDING GEAR ASSEMBLY:
1. Locate the supplied main and tail wheel landing gear parts and sort them out on your workbench.
2. Bolt the main gear to the bottom of the fuselage using the supplied bolts. Use a small drop of thread-
lock to secure the bolts in place.
3. Install the main wheel axles to the composite landing gear and tighten the nylon-insert lock nut. Note
that the axle is a hex head bolt. The hex head part of the bolt is to the outside of the wheel. Use 1-2 nuts to
space the wheel from the axle for wheel pant fit. Insert axle and wheel in main landing gear and use a
nylon locking nut to secure axle and