Juniper QFX5220-128C Quick Start Manual

Text of the manual

Quick Start Guide

QFX5220-128C Quick Start Guide IN THIS GUIDE System Overview | 1 Tools and Parts Required for Installation | 2 Part 1: Mount the Switch into a 4-Post Rack | 3 Part 2: Ground the Chassis and Connect Power | 5 Connect Power to the Switch | 6 Part 3: Connect the QFX5220-128C to the Network and Perform the Initial Configuration | 8 QFX5220-128C

Tools and Parts Required for Installation

The Quick Start Guide is designed to show the basic installation and startup procedures. For complete instructions see the QFX5220 Hardware Guide at QFX5220 Switch Hardware Guide. Gather the tools and equipment listed in Table 1 for installing the switch in a 4 post rack. Table 1: Inventory of Components Supplied wit

Part 1: Mount the Switch into a 4-Post Rack

CAUTION: A QFX5220-128C requires two people for installation, one person to lift the device into place and another person to attach the device to the rack. If you are installing the QFX5220 above 60 in. (152.4 cm) from the floor, you can remove the power supplies and fan modules to minimize the weight before attemp

NOTE: There is a left mounting rail, stamped LEFT, and a right mounting rail, stamped RIGHT. The mounting

rails are not interchangable. Figure 2: Attaching Mounting Rails to the QFX5220-128C Chassis g051183 QFX5220-128C Right mounting rail Left mounting rail 7. Use the Phillips number 2 screwdriver to attach the front of the mounting rail to the flange and c

12.Continue to support the switch while sliding the two mounting blades into the two mounting rails. Secure the mounting

blades to the rack using the eight remaining mounting screws (and cage nuts and washers if your rack requires them). Tighten the screws. See Figure 4. Figure 4: Slide Mounting Blade into Mounting Rail g051185 QFX5220-128C 13.Ensure that th

Figure 5: Connecting a Grounding Cable to a QFX5220-128C

g051191 2. Connect the remaining end of the grounding cable to a proper earth ground, such as the rack in which the switch is mounted. 3. Dress the grounding cable and ensure that it does not touch or block access to other device components and that it does not drape where people could trip over it. Co

c. Insert the power cord coupler firmly into the AC inlet on the power supply faceplate.

d. Slide the power cord retainer loop towards the power supply until it is snug against the base of the coupler. e. Press the tab on the loop and draw out the loop to enclose the power cord. See Figure 6. Figure 6: Attaching the Power Cord Retainer g051161 WARNING: Ensur

Part 3: Connect the QFX5220-128C to the Network and

Perform the Initial Configuration Connect the QFX5220-128C to your network for out-of-band management: 1. Connect one end of the Ethernet cable to the management port (labeled Mgmt) on the QFX5220-128C. 2. Connect the other end of the Ethernet cable to the management device. You must perform the initial con

Other Switch Manuals